Top-rated roofers.

Get matched with top roofers in Union, SC

Enter your zip and get matched with up to 5 pros

Need a pro for your roofing project in Union, SC?

Select your specific project to find the pro for you.

TRUSTED BY UNION, SC HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon33
    Verified roofing services reviews
Roofing questions, answered by experts

No, you do not need gable vents if you have a ridge vent. In fact, gable vents would actually interrupt the process that ridge vents are set to conduct. You would be better off to decide between the two depending on your home’s needs.

The amount of hail damage that warrants a roof replacement depends on the size of the hail. In many cases, a roof replacement is needed if your roof gets hail that is 1 inch or larger in diameter. You may also need to replace a roof due to hail damage if you notice several dents in the shingles or there are seven to 10 hail impact marks within a 10x10 foot area on your roof.

No, there’s no specific building code that requires a roof overhang. However, installing your roof with the standard 2-inch overhang is good practice, as it helps direct runoff away from your fascia boards and roof decking and into your gutters. Some overhang is especially important in areas that see heavy rainfall and snowfall, as the risk of water getting under the roofing material and causing water damage is much higher.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

  • Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

  • Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

  • Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

Yes, shingles should overhang the drip edge, typically between 1/2-inch and 3/4-inch. An overhang shorter than 1/2-inch can allow wind-driven rain to get under the shingles and damage the roof deck or fascia. Conversely, an overhang longer than 3/4-inch increases the risk of shingles getting caught by strong winds, which can lead to roof uplift. Always check your local building code for exact overhang requirements in your area.