Get matched with top roofers in Pauline, SC

You shouldn’t put a new roof underlayment over an old one for a few reasons. Old felt must be removed in order to assess the condition of your roof decking, such as rotting wood or other structural issues. Also, if your roofer doesn't install a fresh layer of felt as is required by shingle manufacturers, your warranty may be voided. Finally, old underlayment removal is often included in the cost of roof repair or replacement, so there's no real benefit to leaving it on before installing a new layer.

No, there’s no specific building code that requires a roof overhang. However, installing your roof with the standard 2-inch overhang is good practice, as it helps direct runoff away from your fascia boards and roof decking and into your gutters. Some overhang is especially important in areas that see heavy rainfall and snowfall, as the risk of water getting under the roofing material and causing water damage is much higher.

The most important thing to remember when laying shingles is to work from the bottom of the slope to the top. This leaves you with a top overlap that directs runoff from one row to the next until it reaches the eave for disposal. You should also make sure you follow the manufacturer's instructions and the local building code for nailing patterns and frequency so all of your hard work stays put through varying weather conditions.

No, you can’t use your home’s square footage. You have to calculate your roof’s square footage, and then you may have to convert your square footage measurement to correspond with how the roofing material is measured. For instance, some roofing is sold in “squares,” which equals the total square footage of the roof divided by 100. Shingles are sold in bundles that may not correspond to the number of squares you need. Metal roofing is sold as sheets, so determine the amount of square feet each panel will cover and then divide the total square footage by the coverage area.