Get matched with top boiler installation pros in Arlington, MA

"The owner Eric was very responsive. He came over to measure and give me a quote very quickly and was able to have the work done the next morning. Kyle and Charlie that did the work did a good job, were professional, did clean work. They did a good job helping me understand the process."

"Over charged my father for a backwater valve repair gave him an invoice with no specific breakdown on the job that was done. Had to request for a breakdown invoice Charged him $4k for a 4 hour job that was not done properly as the basement re flooded again. Gave me a run around for 3 weeks to get a breakdown on the invoice. As you can see from the screenshot.poor work Watch out for these guys. They don’t get the job done and they overcharge. We had to also pay for their the permits they were suppose to already have. And also pay for the rental truck and fuel! Second image is from the basement re flooded again after work was done"

"Patrick was great. He pulled a Rat from my kitchen line so great service!"

"I would not hire these guys again"

"Prompt & efficient, the outcome was a 9.9 out of 10. Price was very reasonable. Jobsite clean with nothing left behind."

"I hired Merrimack Valley Plumbing to install a boiler in my home, and my experience was overwhelmingly disappointing. While the boiler functions, the installation process and quality of work raised numerous red flags. I want to share my experience to help others make an informed decision when considering this company. Installation Issues Code Violations: The exhaust is less than 3 feet from the gas meter, and the holes drilled in the joists for intake and exhaust are less than 2 inches from the bottom, both of which do not meet code requirements. Improper Venting: Both the exhaust and intake vents are installed too close to the ground (not meeting the 12-inch clearance required for expected snowfall) and are too close to each other (less than the 12-inch separation required). Unsealed Penetration: The hole drilled in the siding was left unsealed, creating a potential entry point for rodents. Condensate Drain Issues: The installed condensate pump is leaking and wasn’t tested. Additionally, rather than a permanent drain installation, they daisy-chained it into a pump for a portable air conditioner. Wiring Errors: The zones for the primary bedroom and second floor were wired backward, causing overheating in both areas. Missing Outdoor Sensor: The outdoor temperature sensor, critical for proper operation, was not installed. No CO Alarm: A carbon monoxide alarm was not installed, which is essential for safety. Unprofessional Workmanship: Trash, including a metal duct pipe, was left in the crawl space near live electrical wires. Process Concerns Permit Delays: The company failed to file permits before starting work. I only discovered this after contacting the town permitting office myself. Mismanagement and Delays: The project stretched far beyond the promised timeline, with repeated excuses about missing parts and limited crew availability, despite prior assurances that the job would be completed in two days. Broken Promises: They claimed a project manager would take measurements in advance to ensure a smooth installation, but no one came. Additionally, they rescheduled initially, promising a larger crew, only to send a single plumber on the first day. Misinformation and Deception Throughout the project, I encountered multiple instances where Merrimack Valley Plumbing provided misleading or false information: - They lied about the dates permits were filed. - They claimed delivery issues caused delays, though they should have anticipated these based on the advance photos provided. - They repeatedly shifted blame rather than taking accountability for the delays and issues. Overall Experience While the boiler itself works, the installation was riddled with code violations, safety oversights, and poor workmanship. Additionally, the company’s lack of transparency and repeated dishonesty made an already frustrating situation worse. I would not recommend Merrimack Valley Plumbing to others. Their lack of professionalism, disregard for safety codes, and failure to take responsibility for their mistakes created an unnecessarily stressful and costly experience."

"I used to like them. Use them for my big install of backup basement sump pump. This time, I was out of the country, my rental property in MA needs a toilet fix. It was a standard water tank leak and we need to replace the inside mechanism. Milltown came and said 'rebulid the toilet', my wife authorize them to do it as I was not reachable at the time their plumber was at the rental property. They were in and out according to my tenant for at most 45 min, rebuilding two toilet tank and fixed the leak. The bill came to be 1200, $600 a toilet. One line item on the receipt is $470 for the kit they use to replace the plastic mechanism inside the water tank. I casually google the kit, I can get a universal sup kit for the toilet to replace that for $20. I called them, manager came on gave me that talk - we did hundreds of toilet leak and we average all of them to come up with the cost for that line item, which includes (a) parts (b) labor (c) our service guarantee for a prompt and reliable service Say they charge $200 /hr labor, 1 hr for two toilet is $100 labor for 1 toilet (remember, the plumber was there like 30-45 min rebuilding the two toilet). Say total parts are $100 (with markup), we are talking about $200 for fixing the leak of 1 toilet. They charged almost $600 for one toilet. You can do that math. I expect some up charge, but I am not paying $300 just for getting prompt reliable service. I turned around and asked for a few reliable plumber quote from Thumbstack with great reviews, most can do the job for $200 labor and I can get them the universal kit they will be able to come on the same day. So maybe if you want Milltown to do bigger job, that is ok. For smaller job, it does not worth it. Replacing the toilet flush mechanism is really not rocket science in plumbing. If I am not thousands of miles away, I would have done it myself after watching some Youtube video. I am willing to pay up charge for the service, but this is really above and beyond the normal up charge range, $1200 for a 30 min job replacing the toilet flushing mechanism in the water tank!!"

"I booked a service and was given a 4 hour window. The technician apparently arrived about 1 hour before the window, claimed to have called me but left no message and simply left with no availability during the actual 4 hour window that was promised. This is poor service and I have no heat. Unbelievable and unprofessional."

"The work was done correctly and promptly, but quite expensive. On the plus side, he presented all the options and didn't really try to upsell. Just the facts."

"Nick’s response time, quote, and work was outstanding! He was able to fit me and do the repair quickly and it is much appreciated. Thank you!"