Get matched with top above ground pool installation pros in Browning, MT

Pool leak detection dye is a great way to test specific areas of your pool for unbalanced water flow. By releasing the dye close to possible trouble areas—like around the seal of the skimmer—you can narrow down the potential crack. However, it's best to call a professional pool repair team near you if an initial patch does not keep your water level from lowering.

In combination with adequate filtering and water chemical balance, vacuuming will keep your pool from being overrun with algae. If your pool is experiencing algae growth, the same combination will get rid of it with a bit of patience. Heavy algae growth may require the use of an algaecide, and in some cases, you’ll want to vacuum the pool 24 to 48 hours after using algaecide to remove dead algae debris.

Water only runs through a pool heater when not in use if the heater doesn’t have a bypass system. A bypass system stops the flow of water through the heater when not in use. If you don’t have one, then yes, water will still run through the pool heater even when not in use. Not having a bypass system may increase the effects of wear and tear on your pool heater or disrupt the water’s chemical balance.

How often you should add water to your pool depends on how quickly the water evaporates. Keep an eye on your skimmer box, if you have one. Top up the water in your pool if you notice the water levels are lower than the bottom third of your skimmer. This helps prevent damage to your pump. 

Replace all the water in your pool every five to seven years, depending on how often you use your pool, the weather, and whether or not you close your pool for the winter.