Get matched with top sink repair pros in Santa Fe, NM

The standard kitchen sink size is typically 22 inches by 30 inches. However, kitchen sinks are available in a wide range of sizes to fit different kitchens, commonly from 25 to 39 inches long, though you can find even larger or custom sizes. When choosing a replacement, the easiest option is to select a sink that matches your existing one's dimensions. If you decide to install a larger sink, you will need to enlarge the cutout in your countertop; be sure to use the template that comes with the new sink to ensure a proper fit. Installing a smaller sink can be more complex, as it may require replacing the entire countertop.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

Yes, you can remove an undermount sink from granite countertops. However, it’s safest to hire a granite pro to take on this job. Your pro might have to make cuts and grind the granite to remove the sink. Plus, if you’re replacing your sink with a larger one, you’ll need your pro to enlarge the existing sink cutout in your granite.

Porcelain and enamel sinks have very similar appearances, but they aren’t the same. Porcelain is a ceramic made from natural clay, while enamel is a strong powder that’s glazed over a metal sink. Use a magnet to determine whether you have an enamel or porcelain sink. If a strong magnet sticks to the sink, it’s likely enamel. If it doesn’t, you probably have a porcelain sink. You can also use the model number on the sink (often found on the underside of the bowl) or information from the manufacturer to determine the material.