Get matched with top sink repair pros in Chimayo, NM

Many parts of your plumbing system can fail, but clogged drains are one of the biggest plumbing problems you’ll likely encounter. From your kitchen sink, bathroom sink, or bathtub, there are plenty of opportunities for gunk, hair, food scraps, and more to get stuck in drains. When this happens, water will slowly drain, leading to standing water, bad odors, drain flies, and other issues.

Many homeowners can handle a minor clog themselves, but if you have a clog in your main line, you’re best off hiring a local plumber to get the drain back to its normal flow rate.

There are several types of sink drain stoppers, including pull-out, twist-and-pull, and pop-up. Pull-out sink stoppers can be removed by pulling on the stopper until it comes out of the drain. A twist-and-pull design requires lifting then turning the stopper to lock it in an open position and the opposite action (turning, then pressing down) to close it. A pop-up sink stopper works by pushing down the drain cover to open or close the passageway. 

Emergency plumbers charge a significantly higher rate than for standard service, typically 1.5 to 3 times the normal hourly cost. You can expect to pay between $100 and $500 per hour, with an average of around $200 per hour. In addition to the higher hourly rate, many plumbers charge a flat emergency service or trip fee, which can be between $150 and $300. The final cost depends on the timing of the call; prices are highest for major holidays, followed by weekends and after-hours service on weekdays. For a complex job on a major holiday, a master plumber's rate could reach as high as $600 per hour.

While unplugging your garbage disposal and plugging it back in may help, most units have an actual reset button, a bright red switch found on the underside of your unit. If your garbage disposal needs resetting, you may notice this button sticking out about a quarter of an inch from the surface of the unit, with which it’s usually flush. Simply depress this reset button to reset the unit, and then test to ensure it’s working about 10 minutes later.