Top-rated electricians.

Get matched with top electricians in Sublimity, OR

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Sublimity, OR?

Select your specific project to find the pro for you.

TRUSTED BY SUBLIMITY, OR HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon195
    Verified electrical services reviews

Find Electricians in Sublimity

Avatar for Connections Electric Group Inc.
Connections Electric Group Inc.
5.0(
5
)
Electrical Switches, Outlets & Fixtures - Install or RepairElectrical Wiring or Panel UpgradeElectrical Switches, Outlets & Fixtures - Install or Repair - For Business+7 more

Serving Sublimity, OR and surrounding areas

Approved

In business since 1990

Free estimates

Emergency services offered

Since 1990, Connections Electric has been the trusted name for electrical services in Salem, Oregon. As a leading electrical contractor, they specialize in a full spectrum of solutions, catering to the unique needs of residential, commercial, and industrial clients. From routine maintenance and electrical repairs to complex new construction wiring and energy-efficient upgrades, their experienced team is committed to delivering reliable, high-quality results. Connections Electric ensures every project, including low-voltage systems and emergency repairs, is handled with meticulous attention to detail and a dedication to customer satisfaction. "We harness the power of the Gods and make it work for you!

9 neighbors recently requested a quote
...
Showing 1-10 of 102
Electrical questions, answered by experts

The American Wire Gauge system calculates wire size diameters using the complicated formula D(AWG)=.005·92((36-AWG)/39) inch. A simpler rule of thumb is that every six-gauge decrease doubles the wire diameter, and every three-gauge decrease doubles the wire’s cross-sectional area. On the other hand, wavenumbers are typically measured in reciprocal meters (1/m or m−1) or reciprocal centimeters (1/cm or cm−1).

There are a few reasons your lights may be on, but the rest of your electrical outlets and appliances are not working. The first is that while one circuit blew out, the lights may be on another circuit than your other electrical fixtures. Alternatively, your powerless appliances may be plugged into a GFCI outlet that was tripped and needs to be reset. If these issues aren’t responsible for the problem, you may have dead outlets or a wiring issue. Either way, you should contact an electrician to identify and fix the issue.

This depends on how many outlets you have and the current status of your electrical system. The cost to ground an outlet clocks in at $75 to $480 per outlet, so multiply that by the number of outlets in your home to arrive at a rough estimate. However, this is for simple projects with no obvious issues with the system. Your final bill could vary widely from your calculations.

Yes, you can put a dimmer on a three-way switch, but it can’t be the same kind of dimmer you’d put on a standard light switch. A three-way switch requires a three-way dimmer. If two switches control a single or multiple lights, then you need a three-way dimmer. The type of light bulb should also be compatible with your fixture and dimmer.

While the National Electrical Code (NEC) does not set a strict limit, a common guideline is to have a maximum of eight outlets or receptacles on a 15-amp circuit. This rule of thumb, which equates to about one outlet per 1.5 amps, helps keep the total electrical load safely below 80% of the circuit breaker's capacity. It is important to consider the power demands of any devices or appliances that will be plugged in, as overloading a circuit can lead to tripped breakers or create a fire hazard. To ensure the safety and code compliance of your electrical system, consult with a licensed electrician.

The Sublimity, OR homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.