Best roofers near New Paris, OH

Roofers don’t typically replace vent pipes themselves, but they do handle the flashing and seals around vent pipes when working on a roof. During a roof replacement or repair, roofers inspect the vent pipe flashing for damage, replace deteriorated seals, and ensure the pipe is properly integrated into the roofing system to prevent leaks. If the vent pipe itself is cracked or damaged, a plumber is usually required to replace it, while the roofer ensures the roofing components around the pipe remain watertight.

Many roofers remove satellite dishes as part of their services, especially during roof repairs or replacements. However, they typically won’t reconnect or reinstall the dish. If you no longer need the dish, roofers can dispose of it, but for reuse, you may need a satellite technician to handle reinstallation.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.