Get matched with top septic tank pros in Johnstown, OH

The average cost to replace a septic tank or install a new system is typically around $7,350, with a broader average range of $5,000 to $12,000. However, total project costs can vary widely, from $5,000 to as much as $22,500. Key factors influencing the price include the size and type of the septic system, the tank material, and the size of your house.

It's important to distinguish between the cost of the tank itself and the cost of the entire system installation, which is significantly more. For the tank alone, costs vary by size:

• A tank for a one-bedroom house typically costs $500 to $900.

• A 1,000-gallon tank, suitable for most one- to three-bedroom homes, costs between $900 and $1,500.

• A tank for a five- or six-bedroom home generally costs $1,200 to $1,600.

Yes, shower water goes into the septic tank. Shower water is a type of greywater, and in fact, all water used in a home with a septic system—including water from sinks, toilets, the dishwasher, and the washing machine—drains into the tank. When shower water enters the tank, debris like soap and hair travels with it. The solid debris sinks to the bottom to become sludge, while soap residue joins the scum layer at the top. The remaining water is treated in the tank before moving to the drain field for further treatment and dispersal. It is important to avoid putting oil or harsh chemicals down any drain, as they can cause clogs or disrupt the beneficial bacteria required for proper wastewater management in the septic system.

A gurgling toilet usually doesn’t mean that your septic tank is full. If waste can’t drain into a full septic tank, you’ll see water and sewage backing up into your fixtures, but the air that causes gurgling is a result of poor venting. You are more likely to have a clog in your vent stack or a damaged air admittance valve.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

• If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

• If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.