Get matched with top water softener pros in Eatontown, NJ

"They did a great job. very timely, clean, and everything works."

"as advertised"

"not good gave me another leak"

"Quick and courteous"

"They were absolutely delightful to work with! The staff was very knowledgeable and friendly. They followed up and were able to answer our questions. We will definitely hire them for any future water treatment or equipment we may need in the future."

"Three certified Carrier installers visited our home, inspected our two central a/c units, listened to our needs and provided estimates to replace. All three were professional but Brown’s was a clear winner. Sales manager Joe provided a comprehensive but easy to understand explanation of his proposal. Joe’s technical background enabled him to answer all our technical questions. Throughout the evaluation process we made additional inquiries and Joe always responded in a timely manner. The proposal was detailed and competitive. The install team was exceptional in terms work quality, courteous and respecting our home. The installation exceeded expectations because of small but important details that most never notice. The office team handled scheduling, questions and prepared rebate forms to support an exceptional customer experience. The entire team takes price in their work. We highly recommend Brown’s for air conditioning sales and service. "

"Excellent. Fast response. Reasonable rate. Service very quick. Service tech excellent. Work perfect. Highly recommend."

"This past weekend I had a bad experience. The short story is that an A. J. Perri technician diagnosed my furnace problem and wrote me an estimate for $1,600, parts and labor. It turns out my furnace had a different problem that required no parts and only 15 minutes of labor. Here are the details: This past Saturday my furnace stopped heating my home. I called A.J. Perri and they sent out a technician on Sunday morning. The tech ran some checks and concluded that my “inducer assembly” had to be replaced. Parts and installation would be $1,600. He said someone from the office would contact me on Monday and let me know when they could have the part. He also said that he couldn't be certain that there weren't other issues that wouldn't be found until the inducer was repaired. After the technician left I did some searching on the Internet. YouTube and Reddit were especially helpful. I discovered that the problem was that the condensate drain was clogged and water had backed up into the inducer assembly. The water prevented the pressure switches from detecting that the inducer was running and this prevented the furnace from starting. When I disconnected the condensate hose *2 quarts* of water drained out of the inducer assembly! This water was supposed to drain into a small pump unit on the floor that sends collected water to the sump. Over the years mold and algae had clogged the condensate trap and caused the backup. I disconnected all the hoses and removed the trap. I blew out the trap (making a mess) and confirmed that water would easily flow through it. I put it all back together and the furnace is working fine. The sad lesson here is that you can’t always rely on supposed experts. The good news is that the Internet can be your friend. Even more details: The original symptom was that the furnace would start up, the inducer motor would run for about 20 seconds and then it would shut off. This cycle would repeat every few minutes. Every few hours the furnace completed the startup cycle and then I’d get heat. Then it would stop heating for hours, and the indoor temperature would drop to the low 60s. What I learned from YouTube is that there are multiple stages for furnace startup. The inducer motor spins a cage that sucks in fresh air for combustion, and then pushes the hot gases through the heat exchanger and out the flue. Each stage in the startup has safety checks. The furnace will not ignite if the pressure sensors don’t detect that the inducer motor is working properly. Water is a byproduct of the combustion. It starts as a vapor but then condenses in the flue pipe and drains back to the inducer assembly, where it’s supposed to run through a hose to a pump that sends it over to my basement sump. The furnace is 14 years old. Apparently that’s long enough for mold and algae to clog the condensate trap and cause water to back up into the inducer. The 2 qts of water blocked the pressure sensor switches and so the furnace wouldn’t light. Final thoughts: For over 14 years I've had great experiences with A.J. Perri. They replaced my home’s original furnace and Air Conditioner units. They moved our outside A/C unit to the side of our house so we could have more quiet in the backyard. I had them come for periodic heating and A/C maintenance checkups. My impression is that they might cost a bit more, but they were reliable. I'm saddened that I need to post such a negative review."

"On April 21, 2018, Ernest Serghi of American Plumber, LLC gave an estimate to replace the existing 1.5” underground gas line from the gas meter to the pool heater. This line is buried 30”. I told him that I wanted a 1.5” poly gas pipe buried 18” which was specified by the Holmdel plumbing inspector. He agreed to this and I signed the contract. On May 9, 2018, Ernest came to do the job and dug a narrow trench with a small hand-operated trenching machine and rolled out the yellow poly gas line, I measured the depth immediately and told Ernest that it was only about 12” deep and I wanted it 18” deep as he had agreed to. Ernest said the Code only requires a 12” depth and refused to dig the trench deeper. Ernest did the job in just 2 hours since he did not dig the trench 18 inches as he had agreed to. I have photographic evidence that in one area the gas line is only 9 inches deep. This is a violation of NJ Fuel Gas Code 404.9 that specifies a minimum burial depth of 12”. On May 10, 2018, the Holmdel plumbing inspector looked at the job quickly and approved it. However, he failed to measure the depth of the gas line and did not realize that it did not meet the minimum burial depth required by the Code. In the contract job description, Ernest did not specify in writing the 18” burial depth of the gas line that he had agreed to. I should have required this wording since Ernest did not honor our verbal agreement. I have contacted American Plumber, LLC several times in an attempt to have them correct the code violation and adjust the contract price to reflect the work that was actually done. Instead of trying to correct their error, American Plumber, LLC is demanding payment in full and filed with the Clerk of Monmouth County a Notice of Unpaid Balance and Right to File Lien against my property. I have filed complaints about this unscrupulous and dishonest contractor Ernest Serghis of American Plumber, LLC with the NJ Department of Consumer Affairs and Better Business Bureau."