Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Townsend, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Townsend, MT?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Townsend

Install Above Ground Pools questions, answered by experts

An aboveground pool should be level within 1 inch—and it starts to become unsafe after a couple of inches. Any slope will lead to an uneven distribution of water, which will put pressure on your pool’s structure, wearing down the pool liner. In certain cases, it could cause your pool to collapse. Even if you’re within a safe window, you may still notice that the water level is uneven.

An easy way to know whether your sand filter has enough sand is to check how full the filter is and what the sand looks and feels like. The filter container should be two-thirds to three-quarters full of sand. Look for interior marks indicating the ideal sand level. If you put your hand into the sand, it should flow through your fingers without clumping. The filter pressure gauge is also an easy indicator—the right amount of sand leads to normal pressure, while too much or too little sand can cause high or low pressure.

Water only runs through a pool heater when not in use if the heater doesn’t have a bypass system. A bypass system stops the flow of water through the heater when not in use. If you don’t have one, then yes, water will still run through the pool heater even when not in use. Not having a bypass system may increase the effects of wear and tear on your pool heater or disrupt the water’s chemical balance.

Certain pools serve as a middle ground between traditional swimming pools and hot tubs. The two main options are plunge pools and swim spas. A plunge pool (or cocktail pool) is smaller, but you can add spa-like elements such as heating and jets. A swim spa is more similar to a hot tub, but it produces a current that allows you to swim in place (similar to how a treadmill lets you run in place). 

The best way to dissolve algae is to use pool shock. The shock increases the free chlorine levels in your pool, which in turn kills bacteria, microorganisms, and algae. You can opt for granulated shock that you mix with water or a premixed liquid shock.

Keep in mind that using pool shock is just one of the steps you need to take to get rid of algae from your pool. Unless you also brush, vacuum, and clean the filter, your algae problem may return.

The Townsend, MT homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.