Get matched with top above ground pool installation pros in Whitehall, MT

If your pool takes longer than one or two days to fill, you might be dealing with low water pressure. Using a water pressure gauge on your outdoor tap, you can check your water pressure. A reading of 40 psi or below is considered low. A leak, a nearby water shutoff, or several other reasons could cause this. 

If the water pressure isn’t a problem, you could have a low flow rate from clogs, corroded pipes, or other plumbing issues. It’s best to call in a local plumber to get to the root of the issue.

Yes, you can absolutely use a sand filter with a saltwater pool, but you’ll have to make sure you have the right grade of sand to catch smaller particles, just like in a standard pool. To choose the right pool filter, consider the degree of filtration you’ll need. Cartridge or diatomaceous earth filters can remove smaller particles, so they’re better suited for a less chlorinated saltwater pool.

The decision to install a spool yourself or hire an installer depends on the type of spool and location. If you don't have experience with installations, including excavation, plumbing, and electrical aboveground pool kits are available for purchase. Without the necessary skills for a pool install, it would be wise to hire a local pool contractor for the job.

With a regular pool, the water is contained by visible walls that are higher than the water level. An infinity pool has one or more walls that are right at the waterline so they're not truly visible. For an invisible look, the lower wall is often made of glass or clear acrylic. The water laps over the lower edge and into a catch basin below where it gets pumped back into the pool.