Get matched with top roofers in Bridgewater, MI

While there are many benefits to installing a metal roof on your home, there are some downsides, too. Zinc roofs, in particular, are susceptible to corrosion from overly salty air directly near coastal areas. Another potential downside of zinc roofing is that it must be allowed to expand and contract with the weather. This means special attention is necessary to how it's fastened to the home to avoid issues. 

To cap off a chimney flue, start by measuring its width, length, and diameter, if it’s circular. Purchase a cap that fits the flue, and decide whether you want a temporary or permanent model. Then, slide or insert the cap onto the flue and secure it with a screwdriver. Be sure to avoid over-tightening the screws to prevent chimney damage. 

It’s possible to install your chimney cap in some areas, but it’s usually better to hire a professional. Before you attempt a DIY chimney cap installation, check to see if your local building department requires a permit. If it does, you should hire a professional to pull the permit and complete the work for you. Even if you don’t need a permit, getting up on your roof is dangerous, especially if you have an aggressive pitch or slippery roof material, like metal. Hiring a chimney professional guarantees the job is done correctly and keeps you safe from injury.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.