Get matched with top roofers in Pittsfield, MI

In most cases, below 40 degrees Fahrenheit is too cold to replace a roof. The cold affects the shingles, making it more difficult to adhere them to your roof. It also becomes dangerous for contractors to get up on your roof in the cold weather, as there can be ice and slush causing surfaces to become slippery.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

The number of roof vents necessary for a 2,000-square-foot house depends on several factors. The calculation depends on the net free area within the attic and whether your municipality requires a 1/150 or a 1/300 ratio of venting square feet to attic square feet. If you install vents with a square-foot opening of one, you'll need either 14 or seven exhaust vents and an equal square-foot amount of intake vents.

No, you can’t use your home’s square footage. You have to calculate your roof’s square footage, and then you may have to convert your square footage measurement to correspond with how the roofing material is measured. For instance, some roofing is sold in “squares,” which equals the total square footage of the roof divided by 100. Shingles are sold in bundles that may not correspond to the number of squares you need. Metal roofing is sold as sheets, so determine the amount of square feet each panel will cover and then divide the total square footage by the coverage area.