Get matched with top boiler installation pros in Studio City, CA

A furnace is a big unit where gas, heating oil, or electricity heats the air. The warmed air is then pushed back out through ducts and vents. 

A boiler uses electricity, heating oil, or gas to heat water that is pushed into the room through a radiator. This is one of the oldest and most effective ways to heat a house, but radiators can also be unsightly and leave hot and cold spots in the room.

Heat pumps use a refrigerant to move heat from outside into the house and return it to the room through ducts and vents.

Overall, heating your home with an oil furnace tends to be less expensive than heating your home with an electric heating system. Oil heating systems stay warm for longer periods of time without drawing a constant electrical current to maintain a temperature. Plus, heating oil systems typically have a longer lifespan and lower price tag than their electrical counterparts, resulting in short- and long-term savings.

No, there isn’t always water in radiators. In a one-pipe system, water is constantly circulating from the boiler to the radiators and back. In a two-pipe system, water travels through two separate channels: one that goes to your radiators and one that returns back to the boiler so it can heat up again.

Yes. Boilers need water to run without overheating, also known as dry firing. If you run it without a sufficient volume of water, either because of a burst pipe or a leak, you run the risk of damaging your machine or jeopardizing the safety of your home as a whole. When in doubt, shut off your boiler and repair any plumbing issues before turning it back on. Alternatively, consider installing a low-water cutoff (LWCO) before any issues arise. This gadget will protect your boiler by monitoring water levels and automatically shutting it off if it gets too low.