Get matched with top dishwasher installation pros in Sturtevant, WI

Most dishwashers are designed with a standardized width of around 24 inches and can fit into most kitchen spaces intended for dishwashers. However, the height and depth might vary slightly, requiring careful measurements to ensure a proper fit. Certain specialized or compact dishwasher models might deviate from the standard size to accommodate specific needs or non-standard spaces. While many dishwashers adhere to a typical size, measuring the available space accurately is crucial to guarantee a seamless installation.

There are some dishwasher care tips to extend its longevity and keep your dishes sparkling. Not overloading your dishwasher is key to letting water and soap move freely through the unit. Too much soap can stress your dishwasher unnecessarily, causing it to break down sooner. 

Cleaning your dishwasher is essential for its performance, so every three to six months, put two cups of white vinegar in a dishwasher-safe cup on the top rack and run a complete cycle. When done, place ¼ cup of baking soda inside and run a short cycle to eliminate any lingering odors.

To clean an old dishwasher without a filter, start by removing the bottom rack to access the drain area. Use a damp cloth or sponge to wipe down the interior, paying special attention to the corners and crevices where food particles and debris can build up. Pour a cup of white vinegar into a dishwasher-safe bowl and place it on the top rack, then run a hot water cycle to help break down grease and grime. After the cycle, sprinkle a cup of baking soda across the bottom of the dishwasher and run a short hot water cycle to deodorize and further clean the interior. 

To create a siphon break and remove any chance of dirty sink water or water that backs up into the sink from getting into your dishwasher, your dishwasher drain hose needs to have a high loop or an air gap device as part of its installation. All building codes require at least a high loop. In many places, it’s necessary to install an air gap device to meet the code.