Best sump pump installation pros near Karns, TN

Sump pumps remove excess water from the lowest point of your home, which prevents flooding. When a sump pit fills with water, a sump pump pushes that water outside of the basin and into an exterior discharge pipe. From there, the water flows away from your home, so it doesn’t damage your foundation.

If you have a self-cleaning washing machine but you’re still seeing lint, your water pump filter might be clogged. To clean it, you should unscrew the drain hose, then remove the water pump filter. From there, you can inspect it and clean it with warm water before replacing it. Check to be sure your washing machine is functioning by running a short cycle. 

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to move wastewater and solid waste to the municipal sewer or septic tank. However, for fixtures located below grade (e.g., in a basement), gravity is not sufficient.

The purpose of a sewage ejector pump is to actively pump this wastewater and solid waste upward into the main sewer line. Without an ejector pump in this situation, wastewater would have no way to exit and would eventually back up, causing a sewage overflow or flooding in your basement. If all of your home's plumbing is on the main floor or higher, gravity can handle the drainage, and an ejector pump is not needed.

The most common cause of a clogged sump pump is natural debris buildup. As water enters the sump pit, it can carry small pieces of debris that build up over time, or the debris can get caught in the filter. If you forget to cover the pit after cleaning the sump pump and pit, debris can also collect in the pit. Corrosion on the metal discharge pipe can also clog the pump. Additionally, if your pipes freeze, it can prevent water from draining properly and cause a clog.