Get matched with top sump pump installation pros in Powell, TN

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

First, you can try unplugging the two sump pump cords, one for the motor and one for the float switch, then plugging them back in to reset the sump pump. You can also reset the sump pump by turning it off and back on at the breaker. Many sump pumps have a reset button, which you can press and hold for a few seconds to reset the device.

One common reason a sump pump stops working is improper sizing. Different locations need different sizes and power ratings of sump pumps depending on the typical amount of water the pump needs to manage. If your sump pump is too small for the quantity of water, it can overwork and either burn out or reduce the life of the unit. If the pump is too big, it can overwork and burn out early. 

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.