Get matched with top plumbers in State Road, NC

Whether an earthquake gas shut-off valve is required depends on your location and circumstances. Certain cities, states, and even insurance providers mandate them, especially in areas with high seismic activity. In California, for example, while laws vary by county, most jurisdictions require a valve to be installed in newly constructed homes or when a home is sold or renovated. The Los Angeles Municipal Code specifically requires a licensed contractor for installation. Even if not required by law, installing a seismic shut-off valve is a wise safety measure. These devices automatically cut off the flow of gas during an earthquake, which can prevent gas leaks, fires, and explosions. It is recommended to check with your local building department for specific laws regarding installation, permitting, and inspections, and to ensure the valve you install is on your city's list of approved models.

To check the water pressure in your house, you’ll need to use a water pressure gauge, which you can purchase at your local hardware store. Locate your outside water spigot and attach the gauge (following the manufacturer’s instructions). Normal home water pressure is between 40 and 80 PSI.

A standard toilet flange should fit snugly into the outflow pipe and sit level with the subfloor. Installing a new one without first removing the old one will make it impossible to form a seal and keep the toilet bowl bolted securely in place. 

However, if you’re dealing with leakage or wobbling because you’ve installed a new type of bathroom tile (making the floor taller), you may be able to avoid fully replacing the flange by opting for a toilet flange extender. Extenders typically come in kits for easy DIY installation, fit over the existing flange, and bring the drain connection higher.

Toilet handles can get stuck for a couple of reasons, but it’s commonly an issue with the chain. Remove the lid and check the chain’s connection, running from the flapper to the handle arm. Sometimes the chain gets snagged on or against another part of the tank. 

The chain might not have the right tension. For example, a chain that’s too short can make the handle feel stuck. Check that there’s some slack in the chain. Old, worn-out flappers can get stuck, too. In this case, you’ll need to see which size toilet flapper you need.