Top-rated electricians.

Get matched with top electricians in Wisner, LA

Enter your zip and get matched with up to 5 pros

Find Electricians in Wisner

Avatar for Corrigan, LLC
Corrigan, LLC
4.8(
25
)
Lightning Protection - Install or Repair

Serving Wisner, LA and surrounding areas

Approved

In business since 1954

Free estimates

Emergency services offered

"John Corrigan and his sons are outstanding! They did outstanding work installing our lighting rods at a reasonable price. They were prompt, very professional and honest. I would call them again and recommend them to anyone."
Shingle roof air terminal
Residential 1
Residential Spanish tile
Horse stable
Residential 2

+23

Response time1 day
16 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for 4LP, LLC
4LP, LLC
3.9(
11
)
Lightning Protection - Install or Repair

Serving Wisner, LA and surrounding areas

Approved

In business since 1996

Free estimates

Customers say: Quick response

"Very professional Sales and installation staff. No pressure sales here. They did not try to oversell product that were not necessary for our situation. The installation crew worked quick. The install was neat and professional."
Side View
Front View
Front View
Balcony View
River View

+3

Recommended by100%of homeowners
...
Showing 1-10 of 62
Electrical questions, answered by experts

At a minimum, you need an electrician to inspect the house wiring after a fire. The electrician will need to replace damaged or melted wires. If the electrical wiring is old, about 25 years or more, you should rewire the house after a fire. Old wiring can increase the risk of another fire, so replacing the wires is the safest option.

Typically, when a 3-way switch only works when one switch is on, this is one of the most telltale indicators that the switch has gone bad (although this could also be the result of faulty or loose wiring). To diagnose the issue, toggle each switch until the light comes on. Once it’s on, toggle each switch separately again; the switch that doesn’t turn the light off is the bad switch. 

To reset an electric fireplace, first shut the unit off using the control panel or remote control. Make sure the unit is entirely shut down, then unplug it from the power outlet. Wait five to 10 minutes, then plug the fireplace back in and turn it on. This process should reset the electric fireplace. After resetting, make sure to set the thermostat, timer, and other programmable settings to suit your preferences.

If you need to run a wire from the meter to the breaker box, start by turning off the power using the main switch to avoid injury risks from live wires. Then, locate the ground wire from your meter and connect it to the ground bar of the breaker box. Connect the neutral wire using the same method to improve your circuit efficiency.

Next, locate the hot wires running from the main switch to the meter. To connect them to the correct terminals from meter to breaker, unscrew the nuts of the breaker hotwire terminals, insert the positive hotwire, and ensure it’s firmly attached. Finally, secure the wires with electrical tape and wire tie cables before re-securing your breaker box. Keep in mind that this process can be dangerous, so don’t hesitate to hire a local electrician.

No, you shouldn’t immediately reset a tripped breaker. If you don’t know what tripped the breaker, resetting it and continuing the actions that set it off could pose a hazard. It also means your breaker will sustain greater damage if it trips again. If you know the cause of your tripped power, unplug faulty appliances or fix the issues, then reset it, and wait a few minutes before using electricity in that circuit.

The Wisner, LA homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.