Top-rated electricians.

Get matched with top electricians in Urania, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Urania, LA?

Select your specific project to find the pro for you.

Find Electricians in Urania

Avatar for Corrigan, LLC
Corrigan, LLC
4.8(
25
)
Lightning Protection - Install or Repair

Serving Urania, LA and surrounding areas

Approved

In business since 1954

Free estimates

Emergency services offered

"John Corrigan and his sons are outstanding! They did outstanding work installing our lighting rods at a reasonable price. They were prompt, very professional and honest. I would call them again and recommend them to anyone."
Shingle roof air terminal
Residential 1
Residential Spanish tile
Horse stable
Residential 2

+23

Response time1 day
19 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for 4LP, LLC
4LP, LLC
3.9(
11
)
Lightning Protection - Install or Repair

Serving Urania, LA and surrounding areas

Approved

In business since 1996

Free estimates

Customers say: Quick response

"Very professional Sales and installation staff. No pressure sales here. They did not try to oversell product that were not necessary for our situation. The installation crew worked quick. The install was neat and professional."
Side View
Front View
Front View
Balcony View
River View

+3

Recommended by100%of homeowners
...
Showing 1-10 of 86
Electrical questions, answered by experts

Amps describe the amount of energy that can flow through a circuit breaker. Every electrical device that’s attached to the breaker requires about 1.5 amps. While that equates to roughly 13 receptacles per 20 amps, using slightly fewer ensures that your circuit will always have enough energy for sudden power surges instead of tripping when one occurs. In general, 10 to 12 receptacles is recommended for a 20 amp circuit.

Before you start doing anything else, you must call your electric company to confirm their process. It is technically their meter that you’re moving, so there’s really no such thing as free rein. Moving the meter generally involves disconnecting power from the utility company, disconnecting the cables that run into your electrical panel, and dismounting the meter assembly. Once uninstalled, a handyperson will remount and reconnect the wiring in its new location.

The dials on an electrical meter simply represent the number of kWh you have used since it was installed. In a five-dial setup, the left-most dial represents tens of thousands of kWh, while the next dial to the right represents thousands of kWh. The following dials going to the right represent hundreds, tens, and ones.

GFCI outlets help prevent dangers from ground faults that can cause shocks. This is a different issue that a ground circuit can’t fully address. It’s best to use GFCI outlets combined with ground circuits for complete protection for you and your electronics.

A gas stove doesn't always need a dedicated circuit. Unlike an electric range, which uses 240 volts and requires a 240-volt receptacle, a gas stove only uses 120 volts. In some cases, your electrician will need to replace the existing two-pole circuit breaker with a single-pole circuit breaker as well as swap out the existing 240-volt receptacle with a 120-volt replacement.

The Urania, LA homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.