Get matched with top electricians in Clarks, LA

Unfortunately, a partial power outage without a tripped breaker often means you have a major wiring issue or that the breaker itself is going bad. When the power is out in one room but the breaker is not tripped, you need to call an electrician as soon as possible to identify the cause of the problem and repair it.

Single-pole switches are simple circuits designed for lower voltages. As such, they don’t require the complex wiring of switches that need to supply power to larger devices and appliances. This is why single-pole switches commonly go in bathrooms, closets, and other small rooms that power a low-watt light fixture. One wire creates the circuit from the power supply, the other goes to the fixture, and the final wire provides safety mechanisms through grounding.

That depends on your setup. If a circuit breaker already has GFCI protection, then everything connected to that specific circuit is being monitored. You don’t need additional GFCI outlets on that breaker.

However, if the breaker is not GFCI, then you should have GFCI receptacles for at-risk outlets nearby water sources, because they are not receiving protection. Breakers in a breaker box can vary between GFCI and non-GFCI. Look for GFCI labels on the breaker or try to find the breaker model number to look it up if you aren’t sure.

Yes, a whole-house surge protector needs a designated breaker in your electrical panel. You will need to choose a double pole breaker that has two wire terminals so that your surge protector can connect to the breaker. This breaker needs two breaker slots inside of your panel. If you do not have room, then you will either need to adjust some of the existing breakers in the panel box or hire an electrician to install a subpanel.