Best plumbers near Urania, LA

Snaking a toilet is similar to clearing sinks and bathtubs, but there are unique circumstances where you’d have to drain, disassemble, and remove the toilet to fix the clog. For stubborn clogs in the toilet trap, a toilet auger—designed with a shorter cable and a protective plastic encasing—can navigate the tight bends and clear the clog without risking damage to the porcelain. 

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.

When positioning a pot filler, it should be mounted at a height that allows for convenient access without obstructing the cooking area. A general guideline is to place it 18 to 24 inches above the stove. For a more customized height, measure your most-used pots and install the filler 5 to 10 inches above your tallest one. Regarding horizontal placement, while centering the pot filler can be aesthetically pleasing and ensure it reaches all burners, it is often safer to install it to the left or right of the cooking surface. This placement helps you avoid reaching over a hot stove and reduces the risk of the filler itself getting hot from a large boiling pot. If you do choose to center it, be careful to avoid burns.

You’ll need two sizes of pipe to plumb a bathroom. You’ll use a 1/2-inch pressure pipe for your supply lines that run from the fixture to the larger 3/4-inch supply lines that run through the house. For drain lines, you’ll need a 3-inch PVC pipe for your toilet, a 2-inch PVC pipe for stand-alone showers, and a 1 1/2-inch pipe for a shower/tub combo and the bathroom sink. Each fixture’s drain will run to the 3-inch main drain that runs through the house.