Get matched with top roofers in Northfield, IL

You may become so frustrated with the look of moss on your roof that you contemplate whether to clean or replace your roof. Fortunately, you don’t have to go as far as replacing it. After cleaning the moss, you can use a chemical solution to keep it away. For further protection, trim branches that overhang the roof, as fallen seed pods and leaves on the roof allow moisture to collect, encouraging moss growth. Consider adding zinc-coated flashing to the roof, too. As rain washes across the zinc, it leaves zinc particles behind that inhibit moss growth.

A gable roof with steep pitches covered in asphalt shingles or wood shakes is the most popular roof for Cape Cod homes. Asphalt shingles started gaining popularity in the early 1900s, so wood shake roofs, which were popular in the 1700s when Cape Cod homes were first built, are the traditional option. You can further modernize your Cape Cod home by raising the roof in the front, back, or both to add living space and change up the traditional single-gable roof with doghouse dormers.

Asphalt shingles are the least-expensive roofing material. They cost around $10,000 for a 1,600-square-foot home compared to $16,500 for metal roofing or $25,000 for slate shingles.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.