Get matched with top boiler installation pros in Clive, IA

Hydronic and standard electric baseboard heaters differ in how they operate, their cost, and their performance. Standard convection heaters use electric coils to heat the air directly, while hydronic heaters warm a contained liquid like water or oil, which then radiates heat into the room.

In terms of cost and efficiency, hydronic heaters usually have a higher upfront price but are more energy-efficient and cheaper to run over time. This is because the heated liquid retains warmth, allowing the heater to continue providing heat for a while after the thermostat turns it off. In contrast, electric heaters provide heat more quickly but are less efficient.

Ultimately, the better choice depends on your priorities. If you need a room to heat up fast and have a lower initial budget, an electric heater might be suitable. If long-term energy savings are more important and you don't mind a slower heat-up time, a hydronic heater is likely the better option.

The average lifespan of a boiler is typically between 15 and 20 years, though some may last for as little as 10 years while others can reach 30. A boiler's longevity is influenced by several factors, including the quality of the unit, proper installation, and consistent professional maintenance.

The material also plays a significant role. Older boilers made from durable cast iron can last for over 20 years, with some functioning for up to 50 years. However, it's important to consider their lower efficiency, which can lead to higher utility bills. Modern boilers, often made from steel alloys, are designed to withstand high pressure and temperatures and have an average lifespan of about 20 years.

To maximize your boiler's lifespan, ensure it is installed correctly, have it professionally maintained each year, and address any necessary repairs immediately.

Yes. Boilers need water to run without overheating, also known as dry firing. If you run it without a sufficient volume of water, either because of a burst pipe or a leak, you run the risk of damaging your machine or jeopardizing the safety of your home as a whole. When in doubt, shut off your boiler and repair any plumbing issues before turning it back on. Alternatively, consider installing a low-water cutoff (LWCO) before any issues arise. This gadget will protect your boiler by monitoring water levels and automatically shutting it off if it gets too low. 

An expansion tank must always be installed on the supply side, which is the side where the boiler sends water out to heat the systems. That placement allows the water to push against the air and condense properly as it is heated, then circulated through the system. Professional installers can recommend the best place on the supply side for an expansion tank.