Top-rated plumbers.

Best plumbers near Gordon, GA

Enter your zip and get matched with up to 5 pros

Need a pro for your plumbing project in Gordon, GA?

Select your specific project to find the pro for you.

TRUSTED BY GORDON, GA HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon149
    Verified plumbing services reviews

Top-Rated Plumbers in Gordon - Updated Nov 2026

Franklin's Septic
5.0(
18
)
Drain Line Breakage - Camera LocateDrain Line Breakage - Camera Locate - For BusinessFaucets, Fixtures and Pipes - Repair or Replace+6 more

Serving Gordon, GA and surrounding areas

In business since 1979

Free estimates

Emergency services offered

"Franklins crew arrived as schelduled and after inspeccting the pipes and septic system, determined it was NOT the main drain but merely a busted tub drain that had been damaged during a recent remodel. While there they replaced a p-trap, jetted the lines, emptied the septic tank and replaced the busted pipe. Their crew was AMAZING! They knew exactly what they were doing and didn't go out of their way to break the bank. The work was done in a timely manner and I was notified about each repair or procedure in real time via text or photos or call. I was in utter shock that I had been so bamboozled by such a trusted big name national plumber on my 1st estimate and will NEVER use another Septic Specialist/ Plumber unless it is Franklin's. Twice the work for less than half the original estimate and the work was honest and superior. I could not wait to write this review! It is so rare especially as a woman, to find honest contractors. I would highly recommend this company for all your septic and plumbing. There's a certain peace of mind that comes with knowing a company comes with good marks. Thank you Franklin's and thank you Angies List!!!!!"
Recommended by100%of homeowners
...
Showing 1-10 of 82
Plumbing FAQs, answered by experts

The plumbing industry has standardized the sizes for bathtub drains. They are 1 1/2 inches wide to fit all standard bathtubs from 14 to 26 inches deep. The standard sizing is to ensure that the drain fits into the P trap, a special part of your piping that prevents sewer water from bubbling up into your home (yuck).

For a long time, copper was our only plumbing material option. Thankfully, that is no longer the case. Copper pipes have been used since the 1940s and became most popular around 1963. It wasn’t until the 1990s that PVC pipes became popular and began to replace copper pipes. Therefore, a house built before the 1990s without recent updates will likely contain more copper pipes.

First, find the cleanout pipe in your yard. Unscrew the cap—you may need a wrench to do so. Then, get a drain snake. You can use a non-motorized one, but a motorized snake will make the job a little easier. Feed the snake through the pipe until it reaches the clog. Spin the snake continuously, but don’t try to feed it through the pipe anymore. Keep spinning until you feel it break the clog apart.

A toilet flapper will remain open when the chain that it is connected to is too short. The chain should lift the flapper just enough to allow it to open the rest of the way on its own. The chain should have just about half an inch of slack.

Depending on the layout of your bathroom, you may be able to replace a shower valve without removing the tile. The existing hole needs to be large enough to remove your old valve and fit your new valve. If the hole is too small, you’ll need to cut into the wall and remove some of the tile.

The Gordon, GA homeowners’ guide to plumbing services

From average costs to expert advice, get all the answers you need to get your job done.