Get matched with top foundation drain installation pros in Glendale, AZ

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.

You can DIY basement waterproofing in some ways to help save on the overall costs. If your basement isn’t experiencing a lot of water but is noticeably humid, you can try running a dehumidifier that will pull the excess water out of the air. If you notice water leaking due to outdoor drainage issues, you can add downspout extensions to keep rainwater away from your home. 

However, if the problem is more severe and requires a more extensive solution, it’s best to call a basement waterproofing professional to assess the treatment you need and install waterproofing safeguards properly. Since keeping water out of your basement is important, ensuring this job is done correctly the first time is best.

There are a couple of similar alternatives you may consider for a sewage ejector pump, including a grinder pump or a submersible sump pump. Submersible sump pumps protect your home from flooding from outside water, though, rather than handling wastewater from inside. A grinder pump macerates, or shreds, solid waste before pumping it onward to the sewer line.

Whether to waterproof your basement from the interior or exterior depends on several factors, including your budget.

Exterior waterproofing is generally considered the superior method because it stops water at the source, preventing it from seeping into and damaging your basement walls. This approach offers the most protection, making it ideal if you use your basement for storage.

By contrast, interior waterproofing is often less expensive and requires less labor because the area is more accessible.

For maximum protection against water leakage and moisture, applying waterproofing measures to both the inside and outside is the best solution. However, if you must choose only one, stopping water from the outside is the most effective approach to preserve your foundation and prevent damage.