Top-rated masons.

Get matched with top masons in Roland, AR

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Roland, AR?

Select your specific project to find the pro for you.

TRUSTED BY ROLAND, AR HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon37
    Verified masonry services reviews

Find Masons in Roland

Avatar for Plan A Brick And Stone
Plan A Brick And Stone
5.0(
9
)

Serving Roland, AR and surrounding areas

Approved

Free estimates

Emergency services offered

Credit card accepted

"Markus Perry did a really good job. He was punctual, gave me a good price, and did a really good job. I would highly recommend him to anyone needing masonry work."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+30

2 neighbors recently requested a quote
Recommended by88%of homeowners
Avatar for Foundation Pro
Foundation Pro
4.7(
42
)

Serving Roland, AR and surrounding areas

Approved

In business since 1996

Free estimates

Warranties offered

"Excellent experience from start to finish. Ten Pilings installed under foundation footing to level house and close cracks in brick walls. When job was complete, one could not tell that any work had been done. Company representative, Brent and crew chief Rudy were a pleasure to work with. The crew was outstanding. I highly recommend this company and will certainly use them again if necessary."
Maumelle Gymnasium Cheer Center~Commercial Repair
Tuck-and-point mortar repair after lift
Steel Piling Installation on Residential
Drilling 5/8 inch ports through slab
Jessieville School District

+27

1 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for Olshan Foundation Repair
Olshan Foundation Repair
4.6(
17
)

Serving Roland, AR and surrounding areas

Approved

In business since 1933

Free estimates

Warranties offered

"They gave an estimate and described their recommendation. The quote was more than I expected and the proposed work was not going to meet my needs."
Sump Pump Install
Perimeter Prep
Team at Work
Perimeter Trench Cut
Water Lock Plus

+43

1 neighbors recently requested a quote
Recommended by81%of homeowners
Avatar for Planit Dirt Excavation & Concrete, Inc.
Planit Dirt Excavation & Concrete, Inc.
4.3(
18
)

Serving Roland, AR and surrounding areas

Approved

Super Service Award Winner

In business since 1999

Free estimates

Warranties offered

"J.R. and his crew did a wonderful job replacing my driveway. They hauled everything away and cleaned up after the job was finished. I would recommend his company for any concrete job needing to be done"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+6

2 neighbors recently requested a quote
Recommended by88%of homeowners
...
Showing 1-10 of 133
Masonry questions, answered by experts

Yes, you can do German schmear on stone. You can account for the more textured and rough surface of stone by using a large paintbrush instead of a putty knife. A brush allows you to drag mortar across the stone to get it into all the cracks and crevices. However, a brush will cover more of the surface, so you may need a wet sponge to scrub excess mortar and expose more of your stone.

A fireplace is, by definition, an enclosed space where you burn wood or other fuel for the purpose of generating light and heat. A firepit burns wood and is much less expensive to build, but they aren’t technically a fireplace as it isn’t enclosed. An outdoor oven—commonly outdoor brick pizza ovens—often uses wood as fuel, but its primary purpose is to cook food, and you’d rarely just burn wood inside them for warmth or aesthetic reasons.

You may not need a hammer drill if you’re planning on drilling one or two very small diameter holes in brick. For holes with a diameter of 3/16-inch or less, a regular drill with a masonry bit can do the job. However, the bit will heat up quickly, and the process will take significantly longer than with a hammer drill. Prepare to cool your drill bit down in a bucket of water more often.

You should use cement for a chimney crown. The purpose of the chimney crown is to protect the mortar below from water damage and the effects of weather. For this reason, chimney crowns should only be made using cement. When repairing a crown, use caulks and sealants designed for cement repair rather than mortar repair.

Cutting stone comes with a number of safety hazards. First and foremost, if you’re not comfortable with the equipment required to cut stone, including blades and grinders, you could easily injure yourself. The heavy machinery also poses a risk to your ears if you don’t wear proper ear protection; similarly, you need to wear eye protection to keep debris from irritating your eyes.

However, the biggest risk from cutting stone comes from the stone dust. When breathed in, stone dust can be a huge hazard to your lungs. Always wear a face mask when cutting stone to prevent inhaling stone dust, and thoroughly clean the work area when you are finished.

To avoid injury, we recommend hiring a stone-cutting professional, rather than attempting this job yourself.

The Roland, AR homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.