Get matched with top masons in Mabelvale, AR

Brick spalling—which refers to the crumbly, flaky, or pitted appearance that can develop over time—is caused by a few different conditions. These include:

• Climates with constant freeze-thaw cycles

• Use of non-breathable sealants

• High-pressure water cleaning

• Improper installation

While you can’t do anything about the weather, you can preserve your bricks by cleaning them with soapy water and a good old-fashioned scrubbing. Pressure washers may be satisfying to use, but they can eventually wear away the surface of your bricks. If you don’t have advanced-level DIY skills in masonry, you can hire a reputable masonry contractor in your area for your project.

To stain brick, you should use a product specifically formulated for brick, concrete, or other masonry surfaces. These stains are designed to penetrate the porous surface of the brick and bond with it. This is different from paint, which sits on the surface and is prone to peeling, flaking, and trapping moisture that can cause damage. Water-based brick stains are often recommended because they are easy to apply, even for DIYers, and they allow the brick to breathe. Avoid using regular paint on brick, as it will not adhere properly and can lead to future maintenance problems.

Yes, you can limewash surfaces other than brick. Plaster, stone, stucco, and concrete can all also be limewashed. Any porous surface that will absorb the wash is a good candidate for limewash, although it won’t help much with waterproofing. If you choose to limewash over paint, you’ll need to prep before applying it to avoid a powdery, chalky finish. Shiny surfaces like metal or glass can’t absorb limewash, so it’s not suited for these.

When painting brick, each application method has distinct advantages and disadvantages. Spraying is significantly faster but may not penetrate deeply beyond the surface layer. Rolling is effective for working paint into the brick's texture but can be less effective on mortar joints. If you opt for a roller, choose a thick nap of at least a half-inch to ensure paint gets into all the crevices for even coverage. Using a brush is generally not recommended as it is very time-consuming and provides poor surface penetration. Ultimately, a combination of spraying followed by back-rolling is often the best strategy for a durable and even finish.