Get matched with top fire pit installation pros in Tigerton, WI

DIY cleaning is possible, but professionals ensure thorough soot removal and check for hazardous creosote buildup.

When a carbon monoxide alarm goes off, you should always take it seriously. Infrequent and occasional chirps often point to a low battery, a faulty device, or dust buildup (this usually affects smoke detectors and not standalone CO detectors). A continuous alarm signals an emergency, and you should immediately evacuate and call 911. When it comes to carbon monoxide in your home, it’s better safe than sorry.

If a light switch is off, it’s very unlikely to cause a fire. For a fire to start, the switch has to be on, activating an electrical current, and the wiring must be faulty. However, the malfunctioning light switch could cause an intermittent current to move across the electrical wire. This issue could become a fire hazard with another device connected to the wire. You should replace the bad light switch as soon as you notice it or call an electrician.

The damper, located just above the firebox, can open or close the chimney flue. The damper should remain closed unless there’s a fire burning in the fireplace. Closing the damper prevents energy loss through the chimney and cold air from seeping into the home during the winter. Opening the damper helps maintain airflow when there is a fire and prevents smoke and gases from venting into the house.