Top-rated garbage disposal installation pros.

Best garbage disposal installation pros near Bellevue, WA

Enter your zip and get matched with up to 5 pros

Need a pro for your garbage disposal repair project in Bellevue, WA?

Select your specific project to find the pro for you.

TRUSTED BY BELLEVUE, WA HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon4.7k+
    Verified garbage disposal installation services reviews

Top-Rated Garbage disposal installation pros in Bellevue - Updated Nov 2026

Avatar for Aces Four Construction Sewer & Drainage Repair
Aces Four Construction Sewer & Drainage Repair
4.6(
59
)

Serving Bellevue, WA and surrounding areas

In business since 1978

Free estimates

Emergency services offered

"Aces Four installed a sewer cleanout and hydrojetted my sewer line to clean what was diagnosed as "soft blockage". They did this for half the cost of another bid, and also ran a sewer scope. I was very pleased with this work. However, the sewer scope revealed another issue further down the line causing slow draining. Because of water in the line they were not able to make a definitive diagnosis, and the blockage was too far to reach with a snake. Still, they recommended digging out the line at about $8,000. Later I found another plumber willing to attach two snakes together to clear that blockage. After that was cleared, sewer scope revealed cracks/holes that can be sealed without digging out the line for under $4,000. On one hand I really appreciate the job they did for me, and I can understand that they could not make a proper diagnosis with the water in the line. But they did not offer alternative solutions, so I had to call someone else to figure out the issue. Still, I would call them in the future, and in fact just recently did that."
Inspection
Backhoe
Truck
Landscape Preservation
Estimates

+1

Recommended by95%of homeowners
Avatar for Dirt Pros LLC
Dirt Pros LLC
4.5(
38
)

Serving Bellevue, WA and surrounding areas

In business since 2009

Free estimates

Emergency services offered

"I contacted Dirt Pros for an estimate in late March.  He wasn't able to get out to do the estimate for almost a week, but his price was the best of the three I had (the others didn't include placement of the new sod and even with this, Erik was only slightly more with that service included).  His crew showed up on time, performed the work quickly, and remained within budget.  My yard now looks great thanks to the work he performed.  I wanted to install a sprinkler system myself between the time the old grass was removed and the new sod was installed, and he was very accommodating with that. A few days after I had completed the sprinklers, he was there at 7am laying the sod.  He and his guys were very professional, performed very good quality work, and did a good job of cleaning up after they were done.  I'd do business with him again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+5

Recommended by95%of homeowners
Avatar for Vortex Plumbing Inc
Vortex Plumbing Inc
4.5(
623
)

Serving Bellevue, WA and surrounding areas

In business since 2002

Free estimates

Emergency services offered

"Vortex Plumbing did a great job! It was quite an extensive process. It takes days to re-pipe a whole house and I was expecting to be without running water for a few of those. Baldeep did his best to make our inconvenience as little as possible. He and his crew did as much preparation as possible and only had to turn off our water for about 3 hours during the whole process. Vortex Plumbing is a professional and honest company and I would use them again in the future."
Recommended by91%of homeowners
Avatar for The Plumbing Joint Inc.
The Plumbing Joint Inc.
4.6(
299
)

Serving Bellevue, WA and surrounding areas

In business since 1973

Free estimates

Emergency services offered

"I had already removed cabinets and sheetrock from wall, so it was all open. A lot of smoke and mess, from cutting old pipes. Plumber could have warned me so I could have got some air going through house. He was done in under an hour, $565. After seeing it done, I could have done it myself with about $15 in parts.
"
Additional Photos
Additional Photos
Additional Photos
Recommended by91%of homeowners
Avatar for Overlake Heating & Air Conditioning
Overlake Heating & Air Conditioning
4.8(
335
)

Serving Bellevue, WA and surrounding areas

In business since 1957

Free estimates

Emergency services offered

"The installation of our new heat pump was to take two days, and I assumed would be done during normal business hours (8:00AM - 5:00PM). I expected a smooth process and a properly working system at the end of the 2nd day. The experience was not even close to my expectations. Day 1: Old air handler, heat exchanger, compressor pad and compressor were removed; new air handler, heat exchanger, and compressor pad were installed. As expected, the new compressor was placed on the pad, but not connected to inside unit. I observed one of the four-man crew scraping gravel from my neighbor's driveway to put under the compressor pad. When I told him that my neighbor probably would not like that, he said, "It will be OK. I'll smooth out the places I took it from." He couldn't have given a more wrong answer! Late in the afternoon, the electrician (an Overlake subcontractor) arrived to hookup power to the new system, and all four from the installation crew left. (I think at least one of the crew should have stayed until the electrician was finished to verify that the system was working. And maybe to explain to me how to operate the new thermostat!) About 90 minutes later, the electrician was finished, but the system would not turn on. It was not his job to troubleshoot system problems, but with the guidance of someone over the phone, he managed to find two wires that had not been connected by the Overlake crew. He connected the wires, but that made no difference. I was supposed to have backup electric heat working at the end of Day 1. This was important because it was December and the temps were down to 32 degrees at night. After 2 hours of trying to get the system to produce heat, the electrician left at 7:00PM, and an Overlake tech arrived at 8:30PM. At 10:00PM, the tech determined that a circuit board in the air handler was defective, and a new one would have to be obtained and installed in the morning. I managed to get by with two 1500-watt space heaters by closing off most of the rooms. Day 2: Before the techs arrived, I noticed that the compressor pad, with compressor installed on it, was significantly out-of-level. The techs arrived at 10:30AM, and I asked them to purchase a bag of gravel to replace what had been taken from my neighbor’s driveway, and they complied with my request. I also asked them to level the compressor pad which they did. The defective circuit board was replaced, and backup electric heat came on. It took two Overlake techs until 7:00PM to connect the inside and outside units of the heat pump, and attempt to charge the system with refrigerant. However, a valve on the compressor unit was leaking so the heat pump could not be operated until a new valve was obtained and installed the following day. Day 3: Two Overlake techs arrived at 1:30PM, and, I assume, they installed a new valve. What appeared to me that was left to be done at that point was to charge the system with refrigerant, connect a small electrical cable between the inside and outside units, insulate the refrigerant lines, and spot-tie the lines and wires into a neat installation. This seemingly small quantity of work took until 10:00PM to complete, at which time it appeared that I had a working system. Day 4: I had programmed the wi-fi capable thermostat using the owner’s manual on Day 2, so I woke up on Day 4 to two emails from the system telling me about urgent notifications that had occurred in the middle of the night. They were Error Code 99’s – High Torque Lockout. A google of this returned a manufacturer’s document that explained this code was likely due to overcharging the system, and resulted in the compressor shutting down for a while and then restarting for a couple of hours when the error situation occurred again. I called Overlake and they said to run the system only on the electric backup until a tech could come out 4 days later. I think Overlake should have sent a tech out that day since, at that point, they were already two days late providing me with a working system. Also, since my old but still working heat pump had been turned off 3 days before, I was going to be using electric backup for 7 straight days (at least), and that more than doubles my heating bill, at this time of year. Days 5 thru 7: Waiting for tech to return and troubleshoot error code. Day 8: Appointment for tech was scheduled for between 11:00AM and 1:00PM. Tech arrived at 4:00PM, but did call to say he would be late. Between 4:00PM and 10:00PM, the tech removed the refrigerant from the system and then recharged the system with refrigerant. He had determined that the initial charging had been below spec (too little refrigerant was used), and he said that the system should work OK now that it was properly charged. After the crew left, I noticed that there was dirt, installation scraps, and some kind of cream-colored lubricant on the carpet next to the air handler, as well as trash in the crawl space and outside around the compressor unit. In general, they could have done a better clean up. Also, they apparently used the top of our clothes dryer as a work bench since there was a drop of dried, blue PVC solvent on the dryer along with many dirty finger prints. The system has now operated for 5 days without any obvious problems. I now have an installed and operating system; however, given that it arrived from Bryant with two faulty components, and the installation included two wires not connected and improperly charging of the system, I have little confidence in my new Bryant heat pump. However, among all the negative aspects of this project, there were a couple positives: Overlake’s price was almost $2000 lower than their competition, they promptly submitted the necessary data to Bryant for the rebate I was due, and they appeared to provide a neat and proper installation."
Recommended by97%of homeowners
Avatar for All Water Plumbing LLC
All Water Plumbing LLC
5.0(
12
)

Serving Bellevue, WA and surrounding areas

Free estimates

Emergency services offered

Credit card accepted

"Right before Thanksgiving we detected a leak from our upstairs toilet between our floors; and our dishwasher died. I contacted AWP through their web site; the response and scheduling were prompt. Vlad showed up on time, listened, understood the issue, explained what he was going to do then carefully fixed it. Later that day, the Home Depot crew came in to install our new dishwasher and could not complete the job. Vlad was back later that day - on a Friday - and took charge. As calm and unflappable as the first time he took care of doing everything just right. I would definitely hire AWP again. Very few professionals I have dealt with project and deliver such peace of mind."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+24

Recommended by100%of homeowners
Avatar for UNIQ Interiors
UNIQ Interiors
4.9(
52
)

Serving Bellevue, WA and surrounding areas

In business since 2001

Free estimates

"Victor Popa and his team were always very professional, courteous and responsive.  From the written contract to the final installation of the shower door by his subcontractor, Victor was attentive to detail, something my husband and I, who are both attorneys, greatly appreciated.   Not only did all the work turn out well, but Victor was always concerned about trying to minimize the disruption to our household, even to the extent of asking one of his subcontractors to work on a holiday so that he could minimize the delay in getting the shower glass measured and installed.   One of his subcontractors mentioned how differently Victor operates compared with other companies he works for, in that Victor does his best to work continuously on his jobs to get them done as quickly as possible.   He does what he promises in the time he promises it."
Kitchen
Island
Vanity
Shower
Faucet

+11

Recommended by100%of homeowners
Avatar for FT- plumbing, LLC
FT- plumbing, LLC
5.0(
20
)

Serving Bellevue, WA and surrounding areas

In business since 2014

Please call today for a free estimate at (206) 226-2640 \n\n\nWith over 7 years of experience, FT plumbing has been servicing our neighbors with the same care we would our own homes. With excellent craftsmanship, we are able to complete jobs in the most efficient manner from cost to time spent. We look forward to working with our community for years to come. Please call today for a free estimate at (206) 226-2640\n\nWe are licensed, insurance and bonded.\n

Plumbing Project
Plumbing Project
Additional Photos
Additional Photos
Additional Photos

+44

Recommended by100%of homeowners
Avatar for Puget Sound Water Rescue, Inc.
Puget Sound Water Rescue, Inc.
4.7(
172
)

Serving Bellevue, WA and surrounding areas

In business since 2013

Free estimates

Emergency services offered

"They did a free estimate and came as scheduled. I provided the fixture and they charged $275 to install it in a pedestal sink. I would definitely hire them again and I have already recommend them to others."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Recommended by91%of homeowners
...
Showing 1-10 of 129
Install Garbage Disposal FAQs, answered by experts

Garbage disposals can be considered bad for the environment due to their electricity usage, but good for the environment because they reduce the food waste sent to landfills. If everyone used a garbage disposal, it would tax the wastewater treatment facilities in that region, but if we had to choose one of the options, we’d say they are a net positive on the environment when used correctly. 

Replacing a garbage disposal costs anywhere from $150 to $950, but the average cost is somewhere around $550. There are two types of garbage disposal units, and continuous feed disposals tend to cost more than batch feed disposals. Going for an aluminum garbage disposal is also significantly cheaper than choosing a stainless steel garbage disposal. You'll also need to factor in the horsepower of the motor, labor, and the removal and disposal of your old unit.

If the cost of repairing a leaking garbage disposal is close to the cost of replacing the disposal, then fixing the unit might not make sense. When deciding if you should repair or replace your garbage disposal, consider the age of your garbage disposal, the cost of the repair, and whether your garbage disposal has had other problems recently to help you decide if the cost of repairing the leak is better than the cost of replacing the disposal.

No, you do not need a garbage disposal to have a dishwasher. A dishwasher will work without one, and while it's rare to see a home with a dishwasher that doesn't have a disposal, it is possible. The two appliances pair well and are often installed together because a disposal simplifies meal cleanup.

However, your dishwasher should not be used as a replacement for a garbage disposal. Subjecting it to continuous food leftovers can lead to major clogs. If you choose not to install a garbage disposal, you should thoroughly rinse your plates or scrape excess food into the trash or a compost pile before loading them into the dishwasher to prevent plumbing issues.

These appliances certainly increase the number of things allowed down the drain, but they’re not foolproof. There are several items you shouldn’t put in your garbage disposal, according to manufacturers and technicians. Don’t put coffee grounds down the drain. The same goes for eggshells, potato peels, hard foods, onion skins, and any dry, expandable food. Most importantly, never put grease or oils down the drain.

The Bellevue, WA homeowners’ guide to garbage disposal installation services

From average costs to expert advice, get all the answers you need to get your job done.