Get matched with top pool table assembly pros in Sweeny, TX

The steps to fill a swimming pool will depend on your local building codes. However, it starts with draining the pool of all water using a submersible pump. Then your pro will lift the pool shell from the ground or break it into pieces for individual removal. The next step is filling the cavity with dirt and gravel and topping it with topsoil. Once a structural engineer deems the site safe, landscaping can start.

When you’re winterizing your pool, you need to drain some of the water to prevent cracking and warping from ice. Nonetheless, you should never drain all of the water. Ideally, you’ll lower the water level to anywhere from four to six inches below the skimmer. This will protect the structural integrity of the walls, help prevent your pool liner from warping, and reduce damage from debris.

With a regular pool, the water is contained by visible walls that are higher than the water level. An infinity pool has one or more walls that are right at the waterline so they're not truly visible. For an invisible look, the lower wall is often made of glass or clear acrylic. The water laps over the lower edge and into a catch basin below where it gets pumped back into the pool.

It is possible to restore a filled-in pool. If you want to dig up and repair a filled-in pool in your backyard, the process will cost about the same as the cost of installing a new in-ground pool. You might do this if the filled-in pool is causing sinking, swelling, or drainage issues in your yard. A new pool may resolve these problems and increase your property value.