Top-rated boiler installation pros.

Get matched with top boiler installation pros in Maxwell, TX

Enter your zip and get matched with up to 5 pros

TRUSTED BY MAXWELL, TX HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon749
    Verified boiler installation services reviews

Find Boiler installation pros in Maxwell

Affordable A/C & Heating
4.6(
24
)

Serving Maxwell, TX and surrounding areas

Approved

In business since 1989

Free estimates

Emergency services offered

"Went very well. AACH came right out which was desperately needed since today's forecast is pretty high. Nice family run business, 3 generations. They were able to troubleshoot and fix it right away. Ii came out an easy fix with just needing the capacitor replaced. No charge for the service call. I will definitely use this business again for all my HVAC needs.
"
Response time7 hrs
Response rate100%
7 neighbors recently requested a quote
Avatar for O 2 KOOL REFRIGERATION & A/C
O 2 KOOL REFRIGERATION & A/C
4.8(
14
)

Serving Maxwell, TX and surrounding areas

Approved

In business since 2015

Emergency services offered

Warranties offered

"Butch called back right away. Came out in a timely fashion. Got one unit working. Then he said the main board was malfunctioning on the downstairs unit and would have to be replaced. It would cost 1200 or 1300. But if we spent a little extra on a service contract he would wave the trip fee and it would be 1100 something. Okay. We did that. It was too late for him to get the board that day so he came out the next day to install the board. But the unit still didn't come on. He said the thermostat was bad and it would we 300 to 500 to replace the thermostat depending on what we wanted. My husband told him we could do that ourselves. Just by pass it and get the unit working. Then he came down and said that the blower motor was out and it would be 1800 to replace the blower motor or 2400 to just replace the whole unit and then we'd be under warranty again. I told them I wanted a second opinion before we did that. I called Ed & Sons they came out, confirmed that we did need a new thermostat. And said they could rebuild the blower motor for around 100$. I ordered two new thermostats for 300 for both of them and my husband installed the thermostats. The work they did was fine. But I felt like they were more of the school of let's just replace parts until it works or we can sell them a new unit. Rather than what can we fix."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+25

34 neighbors recently requested a quote
Recommended by88%of homeowners
Avatar for Prostar Water Inc
Prostar Water Inc
4.8(
262
)

Serving Maxwell, TX and surrounding areas

In business since 1996

Free estimates

Credit card accepted

"The installation went well. Justin from sales is awesome and took all the inputs and scheduled the installation appropriately. The installation team Doug and JD are excellent. They worked very hard in the hot sun and installed very patiently. Very cooperative, cleared all the questions we have. We had an issue with the drainage of the purifier as it occupied our washer and dryer which prevented our washing machine installation and Costco denied the installation. But upon contacting prostar Doug or JD came and resolved the issue in no time. He installed the washer and dryer as well. Really appreciate the team and their services.."
Recommended by97%of homeowners
Avatar for Aire Serv of San Antonio
Aire Serv of San Antonio
4.6(
104
)

Serving Maxwell, TX and surrounding areas

In business since 1987

Free estimates

Emergency services offered

"We have been very pleased with the outcome of our HVAC replacement.  Matt was very helpful in taking care of our concern that our system be properly sized.  We were borderline between a 4 and 5 ton system and I know that there are load calculations that can be done in order to determine the size of the unit needed based on your house and conditions like insulation, windows, ceiling height, etc.  Matt was the only contractor who offered to take the time to measure everything and actually do the load calculations.  It turned out that with the insulation upgrade we were already planning, a 4 ton unit was the correct size for our house.  So not only did we achieve the benefit of a more efficient unit, we also received an additional benefit of having a smaller unit that draws less power than we otherwise would have had if we had "guessed" and stuck with the original 5 ton size.  
Once we made the decision to hire Aire Serv they scheduled us quickly, were on time and were very tidy while working at our house.  The unit is working great and we can really see a difference in our electric bill so far, roughly 30% difference compared to August last year although we've had a cooler summer so we cannot attribute the entire improvement to the HVAC upgrade but I'm guessing at least a 20% improvement due to the upgrade.  We used 1000 kWh less of electricity in August 2014 than August 2013 which translates to 36% less than last year and 600 kWh less in August 2014 than July 2014 which translates to 26% less when August 2014 was hotter than July 2014.  Our unit was changed out toward the end of the July 2014 billing cycle.
So bottom line, much lower consumption after installing the new HVAC, Aire Serv took care of all the paper work to send to PEC for our rebate and for getting the Trane warranty extended from 5 to 10 years.  Polite, timely, clean, professional and after doing extensive research I know the price we paid is reasonable.  So overall we have been very happy that we chose Aire Serv.
"
Recommended by91%of homeowners
MASTER-TECH AUTOMOTIVE
4.9(
16
)

Serving Maxwell, TX and surrounding areas

In business since 1997

Credit card accepted

"My car displayed an engine warning type message and the temperature gauge stopped working. I called and spoke with Duke, then took my car to his shop right away. Even though it's a short work week, he was able to get a technician to look at my car and fix the issue on the same day. While no parts were needed, his staff had to take time to check for stored codes, troubleshoot the issue, clean/lubricate parts and put them back on. They were able to get it fixed without having to order parts and the temperature gauge is now working again.
An incredibly nice businessman, Duke told me that it didn't take long and didn't require acquiring any parts, so he didn't charge me for the service. In this day and time I was amazed to hear that......and very appreciative. His shop most definitely has my business from now on - oil changes, preventive maintenance, repairs...... anything! I have already referred him to one friend who is in need of a car repair and also highly recommend his shop to anyone for their automotive needs. 
"
Recommended by93%of homeowners
Avatar for Jon Wayne Service Company
Jon Wayne Service Company
4.4(
1,016
)

Serving Maxwell, TX and surrounding areas

In business since 2001

Emergency services offered

Warranties offered

"Repairman arrived late afternoon and diagnosed problem. Had to order motor from supplier. Came back next morning and installed fan motor. Everything went smoothly."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Response time1 day
Response rate100%
Recommended by88%of homeowners
...
Showing 1-10 of 66
Install Boiler questions, answered by experts

Since your boiler keeps you warm and provides hot water to your home, you’re likely to notice issues with heating in your living space right away. The most obvious sign that your boiler is breaking is not getting any heat or hot water. You might also hear some odd sounds coming from your boiler during operation, the flame in your gas boiler is not blue, the pressure is inconsistent, or your boiler is using more energy than it should. If you notice any of these signs, be sure to call a pro right away.

Professional HVAC installation requires licensed expertise in several areas, including electrical- and plumbing-related work. An HVAC team must know how to safely handle regulated refrigerant chemicals and the gas, oil, or propane used in furnaces and boilers. A proper HVAC installation protects your home from energy loss, fires, and even carbon monoxide leaks.

Most home boilers will need an expansion tank. That’s because these boilers are closed-loop systems, where the water is trapped. An expansion tank is needed when the boiler heats the water and it expands, allowing air to condense in the tank to make room for the water. Other types of boilers don’t use an expansion tank, such as traditional steam boilers, but these aren’t as common. And hot water tanks may be able to use a pressure release valve instead. When in doubt, call in a pro to take a look.

An expansion tank must always be installed on the supply side, which is the side where the boiler sends water out to heat the systems. That placement allows the water to push against the air and condense properly as it is heated, then circulated through the system. Professional installers can recommend the best place on the supply side for an expansion tank.

Most installations take 2-5 days, including old system removal and setup.

The Maxwell, TX homeowners’ guide to boiler installation services

From average costs to expert advice, get all the answers you need to get your job done.