Get matched with top septic tank pros in Colman, SD

Yes, it is generally okay to oversize a well pressure tank, and it will not harm your well system. The primary advantage is that a larger tank reduces frequent pump cycling, leading to longer, slower cycles with fewer startups. This can result in less wear and tear, potentially increasing the lifespan of the pump and conserving energy. However, there are drawbacks to consider. Oversized tanks have a higher upfront cost and require more physical space. While not necessarily a bad thing, opting for a tank that is appropriately sized for your well is often the most efficient choice in terms of cost and space.

A septic system's lifespan typically ranges from 15 to 40 years, with a common average of 20 to 30 years. The longevity heavily depends on the tank's material, maintenance diligence, and usage habits. With proper care, lifespans can reach the upper end of this range.

Lifespan by Tank Material:

• Concrete: 20 to 40 years

• Plastic or Fiberglass: 30 to 40 years

• Steel: 15 to 20 years

To maximize your system's lifespan, follow these maintenance best practices:

• Regular Pumping and Inspections: Have the tank pumped every three to five years and schedule professional inspections regularly.

• Mindful Usage: Only flush human waste and toilet paper. Avoid putting items like cat litter, paper towels, cigarette butts, fats, grease, oils, or coffee grounds down your drains.

• Avoid Chemicals: Do not pour harsh chemicals into the system.

• Water Conservation: Reduce the amount of wastewater your system has to process.

• Protect the Drain Field: Avoid driving or building heavy structures over the drain field area.

While you can drain water softener backwash into a septic tank, doing so may cause several problems. One problem is that increased sodium chloride levels from water softener backwash can kill septic tank bacteria, decreasing the effectiveness of this wastewater treatment system. Another issue is that large calcium deposits can eventually stop up the drain field and lead to poor drainage. 

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.