Get matched with top roofers in Tiverton, RI

If you need to replace the roof over your attached garage, a roofing contractor can perform what is called a partial roof replacement that only affects garage roofing. However, it's important to keep in mind that only replacing a portion of your roof creates a situation where your roofing has two different lifespans. You will also miss out on the opportunity for a full roof warranty. In some cases, having two different roofs on your home could increase risks for leaks. When replacing the roof on a detached garage, homeowners have the option to make the project bigger by upgrading their home roof alongside their garage roof. However, this isn't necessary if your home has a newer, properly functioning roof. It is better to try to match the new garage roof to your home's existing roof instead.

The most common roof pitch is 4:12, which means a rise of 4 inches for every 12 inches of horizontal run. However, roof pitch varies widely based on roof design, climate, and even the roofing materials you plan to install. Your building type also plays a role, as flat roofs are common on commercial buildings and some modern homes.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Ideally, you shouldn’t pay your roofer upfront unless you’re special-ordering materials. However, anything between 10% and 15% of the project’s cost is reasonable to pay upfront. Avoid making a final payment until after the roof gets completed.