Best sump pump installation pros near Whitehall, OH

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to move wastewater and solid waste to the municipal sewer or septic tank. However, for fixtures located below grade (e.g., in a basement), gravity is not sufficient.

The purpose of a sewage ejector pump is to actively pump this wastewater and solid waste upward into the main sewer line. Without an ejector pump in this situation, wastewater would have no way to exit and would eventually back up, causing a sewage overflow or flooding in your basement. If all of your home's plumbing is on the main floor or higher, gravity can handle the drainage, and an ejector pump is not needed.

First, you can try unplugging the two sump pump cords, one for the motor and one for the float switch, then plugging them back in to reset the sump pump. You can also reset the sump pump by turning it off and back on at the breaker. Many sump pumps have a reset button, which you can press and hold for a few seconds to reset the device.

To maintain your sump pump, start by checking it every three to four months to ensure it’s in working order. Clear any debris from the pit because blockages can prevent the pump from operating efficiently. You should also test the pump by pouring a bucket of water into the pit. If it turns on automatically and drains the water, it’s functioning correctly. Inspect the discharge line for clogs, and ensure it directs water away from your home. Once a year, clean the pump itself, and consider having it professionally serviced for optimal performance.

You should be fine. Most high-grade grinder pumps have a 24-hour holding capacity within the tank. You can continue to use the facilities so long as the power outage does not stretch into days. In a worst-case scenario, attach a generator to the grinder pump, providing it has sufficient electric capacity.