Get matched with top roofers in Hampton, NH

Metal roofs do not inherently leak more than shingle roofs; when properly installed, they are generally less likely to leak. Asphalt shingle roofs are more susceptible to leaks due to factors like wind uplift, damage from extreme weather, moss growth, and ice dams. Over time, asphalt shingles also lose their protective grit, which reduces their waterproofing capabilities. In contrast, metal is a more resilient material that stands up better to heavy precipitation and high winds. However, metal roofs can develop leaks if they are poorly installed, have improperly sealed fasteners, or experience issues from thermal expansion. For this reason, professional installation and regular maintenance are crucial to ensure a metal roof's longevity and superior protection against leaks.

There should be small gaps between your roof and the walls of your home, and other buildings. These small gaps let building materials shift, expand, and contract with weather and other outside forces, and they prevent moisture from wicking down walls from roofing and gutter systems. Without these strategic gaps, your home’s exterior and its finishes can sustain water damage, decay, peel, delaminate, and crack. However, there is a fine line between a smart gap and a problematic gap—all  gaps should be small, intentional, and covered or filled in with foam insulation to prevent pests from using them as access points.

A roof's ability to handle snow depends on its strength and the snow's weight, as wet snow is much heavier than dry, fluffy snow. While designs in snowy regions often allow for 35 to 50 pounds per square foot, a general guideline is that a typical roof can withstand about four feet of fresh snow, two feet of packed snow, or just one inch of ice. Factors like the roof's age, slope, and support structure also affect its capacity; newer, sloped roofs generally hold more weight than older, flat ones. Ice and ice dams add significant, dangerous weight. Because capacity varies, it is best to contact a professional roofing contractor or the original builder to determine the maximum snow load for your specific home.

Yes, it’s possible to replace drip edge flashing without removing shingles, but it’s not a good idea. You’ll have to lift the bottom shingles up to remove the old drip edge, install the new material, and then lay the lifted roofing material over the new drip edge. Bending roof shingles can cause damage, and if you have ongoing issues with roof leaks that prompt drip edge replacement, it’s a good idea to consider a roof and drip edge replacement to avoid ongoing issues.