Get matched with top roofers in Granite Quarry, NC

You can put new shingles over old shingles, but most municipalities only allow for two layers of shingles before you have to rip off the old roof and start fresh. In some areas, only a single layer of shingles is allowed due to the weight a bundle of shingles adds to your structure. In most cases, it’s a good idea to remove your old shingles before you install new shingles, especially if you suspect that a roof leak may have compromised the decking underneath.

A roof replacement can take anywhere from one to 14 days. For most homes, a full replacement that includes tearing off old materials takes about one to two days, though the average project can last up to 12 days. The exact timeline depends on several factors, including the roof's size and complexity, the type of roofing material, the crew size, and weather conditions. Certain materials take longer to install; for example, metal roofs can take seven to 14 days because the material is more difficult to work with than asphalt shingles, wood, or tile. A re-roofing project, where new shingles are installed over old ones, can take half the time or less. It's also important to factor in the time needed to obtain necessary permits. A professional roofing contractor will typically complete the job faster than a DIY approach.

Whether you should choose a flat roof or a sloped roof depends on your particular situation. Flat roofs tend to be less expensive to install. However, sloped roofs have longer lifespans and stand up better to heavy snow and other inclement weather.

Keep in mind that even a flat roof needs to have a slight slope, usually around 1/2 inch for every foot. If it is completely flat, water will pool and cause damage, either from weight or leakage or rot.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.