Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Drummond, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Drummond, MT?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Drummond

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Drummond, MT and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools questions, answered by experts

For maximum effectiveness, you should keep your solar pool cover on whenever your pool isn’t in use. Covering the pool during the day allows the solar cover to use the sun’s rays to heat your pool, prevent evaporation and heat loss, and protect your pool from debris.

You can usually use the water from your tap to refill your pool, whether it's city water or well water. If you're going to use well water to fill your pool, make sure you have an adequate amount of water available and that the water is free of contaminants. A water delivery service may also be able to bring water to refill your pool.

The steps to fill a swimming pool will depend on your local building codes. However, it starts with draining the pool of all water using a submersible pump. Then your pro will lift the pool shell from the ground or break it into pieces for individual removal. The next step is filling the cavity with dirt and gravel and topping it with topsoil. Once a structural engineer deems the site safe, landscaping can start.

Yes, you can put too much shock in a pool, and it is crucial to follow the directions on the product you are using. Adding excess shock can upset the chemical balance, make the water cloudy, have adverse effects on swimmers, damage pool equipment or surfaces, and even encourage certain types of algae to grow. If you have over-shocked your pool, perform a water test and adjust the chemicals as necessary. The pool's chemical balance will eventually return to normal as the excess chlorine dissipates over time.

In combination with adequate filtering and water chemical balance, vacuuming will keep your pool from being overrun with algae. If your pool is experiencing algae growth, the same combination will get rid of it with a bit of patience. Heavy algae growth may require the use of an algaecide, and in some cases, you’ll want to vacuum the pool 24 to 48 hours after using algaecide to remove dead algae debris.

The Drummond, MT homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.