Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Shepherd, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Shepherd, MT?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Shepherd

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)

Serving Shepherd, MT and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools questions, answered by experts

An aboveground pool should be level within 1 inch—and it starts to become unsafe after a couple of inches. Any slope will lead to an uneven distribution of water, which will put pressure on your pool’s structure, wearing down the pool liner. In certain cases, it could cause your pool to collapse. Even if you’re within a safe window, you may still notice that the water level is uneven.

Installation typically takes 4-8 weeks, including site preparation and liner installation.

While you should avoid draining an above ground pool on a regular basis, it may be necessary if you are experiencing common signs of major pool problems. When you fully drain your pool, do so slowly with the proper equipment and always avoid draining on a very hot day. In many cases, the pool liner and equipment depend on the cooling effect of the water.

It is a good idea to brush a pool before shocking. Brushing the sides and floor loosen up anything that is growing on the surface, such as algae. It is then easier for the pool shock to kill the contaminants because more of it will come in contact with the chemicals.

You should add chlorine within 48 hours of filling your pool with water. In just 24 hours, bacteria and algae will begin to grow and contaminate your water. After that point, you’ll need to shock the water with high levels of chlorine, and you’ll likely need to do additional vacuuming to get the pool clean. It’s important to check your chlorine levels two to three times a week and add more chlorine as needed to maintain a healthy level.

The Shepherd, MT homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.