Get matched with top toilet pros in Williamston, MI

In most cases, it’s better to repair a toilet than to replace it. Fixing issues like low water levels, running water, and flushing problems is less expensive than buying a new unit. Start thinking about replacement if the toilet is cracked, using excessive amounts of water, or is over 15 years old. Newer models are more water-efficient and clog less often than older models.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Some older homes have toilets in the basement to combat sewage backups. This type of toilet, also known as a Pittsburgh potty, acted as a safety valve over the incoming sewer line. If a line backed up, it would back up into the toilet because it was the lowest fixture in the home, keeping it out of sight and away from the finished areas of the house.

Basement toilets were also used by workers with messy jobs, like those who worked in coal mines or steel mills. This way, they could clean up and avoid tracking dirt through their home.

Yes, continuing to flush a clogged toilet is not likely to break up the clog. Instead, it will continue to put pressure on the clog while filling the bowl with more water, which can potentially cause the toilet to overflow—leading to an even bigger mess. Rather than repeatedly flushing, use a toilet plunger or plumber’s snake to dislodge the clog.