Get matched with top drain pipe installers in Berlin, MA

"Damien made time for me on short notice. When he arrived I described the issue and he was quick to correctly diagnose the cause. He had to replace a heating coil in my electirc water heater. During the course of the repair he noted that the drain valve was not working properly. He replaced that as well. Before he left he drained and flushed the tank. All is working well. I'd recommend Damian for this type of service. Damian was delayed because of an earlier appointment where materials had not arrived on time. He worked later that normal working hours to make sure my problems were taken care of. I cetainly appreciated his efforts and that he kept me informed of his arrival time. He did not have to extend his day to the extent he did, but rather than re-schedule me, he completed my job as promised."

"My main service person, Kevin, came in and immediately put on booties. He explained that he would assess the problems and then show me my options and present the costs. When he showed me the options, I was initially surprised by the rates and prices which seemed high to me. Kevin clearly explained the best and worst case scenarios and gave me many options for choosing what work I wanted to do given what I could afford. Another service person, Ari, came to work on the upstairs tub clogged drain. As they were both working upstairs, water started coming through the kitchen ceiling. They immediately halted and came downstairs to help. They placed bowls underneath the dripping areas and then put down a dropcloth. They had to open the ceiling to see where the water was coming from and it was clear that the ceiling was soaked and had been wet for some time. They found a pipe with a big, rusted and corroded hole that was the source of the water. They replaced the pipe and also snaked the line to clear the clog. Kevin replaced the shower valve and installed a new (and better) shower head. Kevin fixed the leaking kitchen faucet. Before they left, they cleaned up every speck and left the upstairs bathroom and kitchen areas cleaner than they were when they arrived. I also have to mention that it was pouring rain throughout the day, and when they had to go out to their trucks they never failed to put on their booties when they came back inside my house. Throughout the day (they were here all day), they were both pleasant, polite and completely professional. Although it cost me more that I had hoped, it was all work that had to be done and I am very pleased with the quality of the work and personnel. I would recommend them."

"Have used Seamus and his team for multiple issues from clearing a clogged drain to a bathroom renovation in my 100+ year old house. He is thoughtful on coming up with solutions for more complex problems. Have been happy with the results every time. Highly recommend."

"Service people are excellent in their profession in what they do. Just under 2 1/2 hours they taken the old water tank out and replaced with the new water tank with new copper pipe connections."

"My pipe broke on a Sunday I found Jeff Bernard on Monday they came right out and fixed the leaks super fast very friendly and professional and reasonably priced I can’t express enough how great full I am to have my leak fixed so fast"

"Topic is a home water supply Shallow Well which operates with a shallow well jet pump + pressure tank installed in the basement. I had been collecting parts over the summer, as I knew the original to house jet pump would go out soon some day and with covid parts are hard to get quick, so started collecting ahead of time. Glad I did as the pump started leaking, from the housing. Replacement needed. Not an emergency but time to get it replaced. Was a ticking clock as it also looked like the pump was twisting putting stress on piping as original owner did not mount it and other fittings had large amounts of corrosion on them. I supplied these parts for the job: new 1hp jet pump, 44 Gal. pressure tank with T package, water filter housing, brass fittings, brass check valve, brass ball valves, 1" copper pipe and some copper fitting, and 2x10 pressure treated board to mount the pump/board to the floor with concrete anchors. Called up Sila on 10/14, master plumber Dave was available on 10/16 to come quote the job of installing what I supplied and misc. parts still needed. Talked with me and received my requests for specific design wants and he supplied his opinions & additional ideas and other options like wall mounting of water filter, sensor shutoff option and different water filter all together and we worked out the plan, did not do the different filter or sensor though. Talked about brass pipe and fittings at the pump up to the pressure tank and we agreed what I had purchased was good and would last a lifetime, vs copper all the way which would still last a long time. Quoted $2800 with water filter bypassing and $2600 without the water filter bypassing. Job was scheduled for 10/22. Quote was high level line item as listed here. Came a bit late on 10/14, due to an emergency call, no big deal Dave called to let me know. Was on time for installation on 10/22, 7:30am. Two workers on Job (Dave + 1, sorry I’m horrible with names +1 was an electrician and was helping Dave) Job took ~ 8 hours to finish. What was not able to be completed: Was not able to replace old original check valve. Well started to suck air when old was started to be removed, confirming there is no foot valve on the line or a broken one, so old check valve was kept. Concern was not being able to recover from air going down the well pipe causing priming issues. At this point the job would require a well expert and was not able to be replaced by Sila. What part of job was mis-understood: Mounting of jet pump to board/floor. Ended up missing the concrete anchors to start and installing after the fact with a different method. Made it more difficult to mount the pump and did scratch the rust proof paint. But it got done. Nice and sturdy. What was complicated on the job: Something that should have not been an issue at all went wrong. I had purchased 1” brass unions. There were two unions installed. One was found to be causing leaks during the initial job installation. This caused extra rework during the initial job. After job completion and area dried with a fan, it was found that both unions were leaking. The original one that had issues in the initial job and the 2nd one. One is pre pump and one is post pump. Called Sila office on 10/23 and told them what was happening, Dave’s earliest availability to come back was was 10/26. He was on time on 10/26. Dave stated that 1 union was giving trouble and replaced it with one spare that I had also purchased. When looking at the 2nd union again he was not able to get it to seal and he made the call and changed the design to direct copper connection and no union, I did not object as at this point just wanted the job done. No More leaks on that location, but also no ability to easily break the connection for future maintenance. When left no leaks. However, after using water for a while the 1st union started leaking again. Texted Dave direct with a picture and said he could return on 10/28 and I requested him to bring a union from his supply. Arrived when he could with ~ 1hr notice and replaced the union with one of his. When looking closer at the issue unions that I had purchased it was found they were cracking. Summary: I’m a novice in pluming, reason for calling Sila. I wish Dave would have noticed the poor part / crack issue and replaced unions from his stock on day 1. I was trying to save time by collecting parts over time and ended up causing issues. Dave knew he was working with brass and seems like he did not have backup stock on site incase of issues. Wish he did as I’d have two unions… and he would not have had to come back twice to repair the leaks. The call was made to not use the brass ball valves I purchased so it was clear that my parts were recommended to use but not absolute. Overall Dave and team did a great job, it’s clean, organized, valves and drain spickets installed nice and logically, filter is at good height, job completed like I asked and planned with Dave, except for the above jet pump mounting, union issue and check valve replacement discussion above here. Dave and team was professional and focused to get the job done. Thanks Dave for your hard work. Reason for Rating: I am giving this job an A rating based on the end result, Sila stood by the workmanship and resolved the issues that arose. That is a sign of a great company. If I would not have supplied the couplers that issue would not have happened ultimately and the check valve & well priming issue was just out of reach and would have required a well specialist to complete. The pump mounting was probably just lost in the large amount of details we had discussed, again it is mounted sturdy."

"First off, the consult was great. I was able to add services to my initial request and received a deal doing so. I also added a second set of services later that month. Adam and Steve completed the work and were completely professional and super efficient. They answered my questions and made sure I understood the work being performed. They worked with my schedule and were fantastic. I had a gas hook-up for a change from electric stove to gas stove - they even took care of the permits and inspection. They removed an old water access point for the fridge's icemaker that was in an awkward spot. They also added a regulator for the water pressure and water filtration system. Fantastic work all around. Should we need any more plumbing/gas work, I would definitely hire them again."

"TPK LLC did an amazing job unclogging my kitchen drain. They were professional, quick, and got everything flowing perfectly again. Great communication, fair pricing, and excellent service. Highly recommend!"

"They advice, and had all our questions answered on sensible and affordable options. Very knowledgeable, prompt, polite, efficient, and thorough team! We are happy with their waterproofing services in our basement (fast sump pump and a grate trench with a discharge line that goes 15 feet to the outside bubbler) as well as crawl space shield installed under our addition. It works well, and Pioneer checked a month later and a year after for inspection and cleaning. A+ work and workers."

"Boyd Property Management did an incredible job installing my new walkway. They came and gave me a great price, showed up to do the job when they said they would, did a great job with the installation, and went above and beyond cleaning up afterward. I am very happy with their work and professionalism, and am going to have them do a patio and retainer wall this spring. I would highly recommend them!"