Top-rated septic tank pros.

Get matched with top septic tank pros in Simpson, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Simpson, LA?

Select your specific project to find the pro for you.

Find Septic tank pros in Simpson

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Simpson, LA and surrounding areas

In business since 1971

Credit card accepted

"I just pay $75 you never know who's going to come out. They do everything electrical. Just about everything is covered except the septic tank. I had an air conditioner replaced. It went great, all I had to do was pay for the freon. He didn't charge e more than what was needed."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Septic Tanks questions, answered by experts

If you notice that your well pump runs continuously, it’s important to take action quickly to avoid further damage. A few common issues may be to blame for a continuously running well pump, such as mechanical damage, a faulty pressure control switch, low water level, prime loss, and leaking pipes and fixtures.

Baking soda does very little to nothing for a septic tank, but it can help unclog a drain or clean out a garbage disposal. Rotten tomatoes and yeast are the best ways to increase the bacteria in your septic tank naturally. You can add these to your system once every three months.

Modern septic tanks have two lids: one that covers the inlet where wastewater flows into the tank and one that covers the outlet where the treated water flows out to the drain field. However, older septic tanks installed before 1975 may have only one lid. Because septic tanks last 20 to 40 years, if yours only has one lid, it may be time for a replacement.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Bladder and diaphragm well pressure tanks are usually pre-charged at the factory. Even so, it’s important to check the air pressure in the tank using a tire pressure gauge on the relief valve. The instruction manual usually calls for 28 psi. Use a hand pump to add more air or release some air from the tank to reach the desired number. Check the pressure periodically to see if you need to add more air to the tank.

The Simpson, LA homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.