Best masons near Saint Michaels, AZ

While painting can certainly change the look of a chimney, you should think twice about giving your brick chimney the old landlord special.

Painting brick is porous, meaning it’s full of tiny holes that can soak up moisture. Those holes also allow it to dry, though. So, when you paint it, you trap any moisture inside, providing an opportunity for mold, mildew, and water damage.

Paint also shows wear faster than naked brick. This means that once you paint a brick surface, you’ll have to keep painting it to maintain a clean look. A paint job is also harder to undo on brick because of its porous nature. Once you paint it, it’s hard to go back without some serious power washing—another added cost.

A mason lays brick or stone together, sometimes with mortar in between the bricks and stones, and sometimes without mortar, also called a dry-stack or surface bonding. Examples of work masons do include:

• Brick, stone, or cement block houses and buildings

• Freestanding stone or brick walls

• Chimneys with wood-burning fireplaces

• Cement block basement or crawl space walls

The cost of masonry work varies widely depending on the type of masonry along with common cost factors like size, complexity, location, and season. Most exterior masonry work done in freezing temperatures tends to cost more because of the preparation and protection involved to keep the masonry from freezing before the mortar cures properly. The average price ranges per project or square foot for different types of masonry include:

• Brick wall (fence, garden wall, etc.): $10–$45 per square foot

• Natural stone wall: $40–$110 per square foot

• Manufactured stone veneer: $20–$40 per square foot

• Brick home exterior: $10–$30 per square foot

• Brick siding: $3–$10 per square foot

• Stone siding: $35–$50 per square foot

• Brick step replacement: $20–$30 per square foot

• Brick wall repair: $20–$40 per square foot

• Chimney repairs: $160–$750 per project

• Tuckpointing: $5–$25 per square foot

It is possible, albeit a lot slower, to break up a rock using water. You would do this by freezing and thawing the water. You could create some initial holes or cracks in the rock, then pour water into the cracks or holes and allow them to freeze (so it's best to do this in winter or in colder climates). Since water expands when it freezes, this puts pressure on the inside of the rock and causes it to crack. You could continue to pour more water in and let it freeze to continue to break up the rock.