Top-rated masons.

Best masons near Greasewood, AZ

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Greasewood, AZ?

Select your specific project to find the pro for you.

Top-Rated Masons in Greasewood - Updated Nov 2026

A-PAC Pressure Grouting, Inc.
4.0(
2
)
Concrete Foundation - Raise

Serving Greasewood, AZ and surrounding areas

In business since 1989

Free estimates

"A -PAC was not too eager to do the job. They never called back after I discussed my chimney problem with Bob. Another company did the repair and did a wonderful job using 4 helical piers stabilizing and jacking the chimney up to it's original position. I would strongly recommend that you include this company in your list of foundation contractors."
 SRP TOWER MODIFICATION
 NEW CONSTRUCTION - UNDERPINNING
 HELICAL PIER BRACKET ATTACHMENT
BRIDGE FOUNDATIONS - PRESSURE GROUTING
 TIE-BACK INSTALLATION

+2

Recommended by100%of homeowners
Masonry FAQs, answered by experts

A fireplace is, by definition, an enclosed space where you burn wood or other fuel for the purpose of generating light and heat. A firepit burns wood and is much less expensive to build, but they aren’t technically a fireplace as it isn’t enclosed. An outdoor oven—commonly outdoor brick pizza ovens—often uses wood as fuel, but its primary purpose is to cook food, and you’d rarely just burn wood inside them for warmth or aesthetic reasons.

Yes, but used or reclaimed bricks can be more brittle, cracked, or uneven than new bricks, so they’re harder to cut cleanly by hand. For that reason, you should take extra care when scoring and striking, and expect a higher chance of breakage. If a brick feels especially fragile, score deeper before attempting to split it.

The best way to clean creosote from brick is to hire a professional chimney sweep. However, you can use a creosote log to remove excess buildup between cleanings. You can also clean minor creosote buildup using dish soap or vinegar mixed with water.

You will repoint over a fraction of the old mortar, but you should scrape away 1/2 to 1 inch of mortar from the joints before repointing. Otherwise, the repointing is only masking the weakened mortar instead of actually replacing it, which could put your chimney at risk of bigger, more expensive damages later on.

A traditional rectangular brick that is used for siding, brick walks, and pathways is 8 inches long by 4 inches wide. If you are shopping for fire bricks, the standard dimension is typically 9 inches long by 4.5 inches wide.

The Greasewood, AZ homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.