Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Kearny, AZ

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Kearny, AZ?

Select your specific project to find the pro for you.

Find Drywall insulation pros in Kearny

Avatar for Marshall Insulation
Marshall Insulation
4.5(
155
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Kearny, AZ and surrounding areas

In business since 1998

Free estimates

Credit card accepted

"I called to set up a free consultation and was promptly met at the agreed upon time. We discussed my desires and how to achieve my project goals. I was given a quote and agreed upon the price for the garage work to be done the following week when I was free. The spray foam and "drill and fill" have been awesome! I have a 24K BTU AC unit in the garage that was unable to keep the temps low as there was so much heat in the garage all day. After the insulation was done it can hold the temps at 70F in the garage while barely turning on during the day. The attic above the garage tops out at 85F when it was over 110F outside, just amazing. We had them do a home energy audit and found that there were plenty of leaky areas in the attic and the insulation was 15 years old and about an R-10 level. It needed some serious work so we agreed to have it topped off with new fiberglass insulation. The guys came out and did and amazing job bringing me up to R-39 as well as keeping the house very clean while doing it. On both days they cleaned up after themselves and took great care of my house. I would wholeheartedly recommend them to anyone that could use more insulation!"
Additional Photos
Additional Photos
Recommended by88%of homeowners
Avatar for AZ Insulation & HVAC Solutions, LLC
AZ Insulation & HVAC Solutions, LLC
4.7(
162
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Kearny, AZ and surrounding areas

In business since 1985

Free estimates

Credit card accepted

"Sam and his partner did a great job overall. Their price was very reasonable for the work they did. After they left and I was working to patch up the drywall holes, I noticed 2 wall openings where the insulation didn't fully fill the walls, due to electrical wiring in one wall and a AC drain pipe in the other wall. I called Sam and they came out promptly and refilled those 2 walls more completely. I didn't give a 5.0 on quality because they didn't use a stud finder to get more accurate hole cuts, and they didn't make extra holes around the area where the electrical box is located, to make sure to fill above and below this box (but as I mentioned above), they did come back promptly to fix the issue as I requested."
Fiberglass Insulation
Fiberglass Insulated
Fiberglass Insulated
Fiberglass Insulated
Fiberglass Insulated

+9

Response time12 hrs
Recommended by96%of homeowners
Avatar for Marshall Insulation
Marshall Insulation
4.5(
89
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Kearny, AZ and surrounding areas

In business since 2009

Free estimates

"The installers showed up on time, were very courteous, completed the job within a few hours, cleaned up and were gone. They did an very good job of installing the insulation and now I can't wait to see my bills go down. The cost of the project was a little more than I wanted to spend but I see it was worth it. It was something I couldn't do myself. I would recommend."
Blown in Fiberglass Insulation
 Spray Foam Seals and Insulates
 Radiant Barrier Saves Money
 The Best insulation you can buy!
 Spray Foam is the Best Insulation

+2

Recommended by100%of homeowners
Avatar for Banker Insulation, Inc.
Banker Insulation, Inc.
3.6(
24
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Kearny, AZ and surrounding areas

In business since 1977

Free estimates

Emergency services offered

"What I was hoping to do didn't make sense so I'm pursuing a do it your self option. I spoke to Jeff Banker personally and he was very helpful, told me my idea didn't make sense since spray on insulation generally looks kind of messy and only makes sense for locations that aren't normally seen. He offered me other ideas and one was simple and easy enough that I'll just do it myself. I will keep him in mind though if/when I decide to spray foam elsewhere in my house. Thanks!"
A re-insulate
Spray Foam Insulation
Spray foam with fiberglass
Federal Tax Credit
Recommended by87%of homeowners
Avatar for Good Attic of Arizona LLC
Good Attic of Arizona LLC
5.0(
6
)
Blown-In Insulation - Install or Upgrade

Serving Kearny, AZ and surrounding areas

In business since 2025

Free estimates

Credit card accepted

"Austin and his crew from Good Attic installed new blown in insulation to my 25 year old home. The work was performed right on time. I have access to my attic in the laundry room and through my kitchen pantry. Both were used to get to different locations in the attic. Both areas were left clean with no residue or debris. The yard where the equipment was blowing in the insulation was left clean at the completion of the job. The price for the service they provided was very reasonable. Austin answered all questions we had for him. We look forward to a savings on our upcoming power bill this summer. I would recommend Austin and Good Attic to anyone wanting to add additional insulation to their home. Thanks again."
Attic Upgrade
Response time10 hrs
Horizon Energy Systems
4.7(
14
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Kearny, AZ and surrounding areas

In business since 1978

Free estimates

Credit card accepted

"Brad told me what to expect before he installed radiant barrier on the south and west walls of our shop, he also installed radiant barrier and foam insulation to the roof on our south building. The results dramatically exceeded my expectations. Prior to the radiant barrier we started work at 5am and stopped between noon to 1pm because of heat, after the upgrades one cooler was able to keep the shop at 72 degrees well into July. We increased our productivity, increased the number of hours worked, and did so in comfort. The transformation has been impressive, our building has gone from the least comfortable work environment I have worked in over the past couple decades, into the most comfortable with the radiant barrier and insulation installed."
Recommended by100%of homeowners
Avatar for The Plumber
The Plumber
4.4(
793
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Kearny, AZ and surrounding areas

In business since 2008

Free estimates

Emergency services offered

"Josh was relentless in fixing leaks we had in our slab in multiple areas.   His attention to detail and his innovation and creative approach to repairing and re-plumbing the hot water line was genius.  He was very conscientious in keeping the dirt and dust down to a minimum which isn't easy when your are cutting through drywall and jack hammering the slab in different areas and always cleaned up before leaving. I would use Leak Dr Plumbing again in a heart beat and would recommend highly. 
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by83%of homeowners
Showing 1-10 of 20
Drywall Insulation questions, answered by experts

Which style of corner bead you choose—whether metal or paper-faced—depends on your preference and if you’re comfortable using metal-cutting tools and a hammer. Metal bead offers superior strength and durability but its installation is slightly more involved. We’d say for most cases, it’s better to use metal bead but if you’re not comfortable working with metal, paper-faced bead will work just fine. 

If you’re installing new drywall, you may need to skim coat the drywall first for a smooth finish and to allow the primer to adhere to the wall. It’s only necessary if there are imperfections in your drywall due to issues with the studs or improper drywall installation. If you’re refreshing existing walls, you may want to skim coat if there are imperfections across the wall. As an alternative, you can repair your drywall and sand it for a smooth finish before painting.

You should leave a gap between drywall sheets because they naturally expand and contract along with the building framing as temperature and humidity change. Most pro drywall installers leave a gap of about ⅛ inch between drywall sheets, allowing the sheets to expand, contract, and shift without cracking or becoming damaged. If you don’t leave enough gaps between slabs, the edges will press against each other when they expand, and the pressure can cause visible cracks.

You should do a little bit of sanding between adding coats of mud. Knock down any ridges or significantly imperfect areas through sanding, which should help you apply the next coat of mud smoothly. If your first coat of mud is pretty smooth after it dries, a quick sanding is all you’ll need. Don’t forget to wipe away any dust after each sanding process.

Applying plaster to a wall will usually cost between $2 and $10 per square foot for both the material and labor. The cost will vary based on the quality of the plaster you’re using and whether or not prep work is required before the work begins. Wall prep can add up to about 10% to your total costs. Plastering exterior walls can be more expensive in many cases because they are taller and require scaffolding and safety equipment.

The Kearny, AZ homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.