If only half of your outlet works, there are usually two possible causes: faulty wiring or a half-hot outlet. The first thing you'll want to do is check the circuit breaker panel to ensure that it's not tripped. If your circuit breaker isn't tripped, turn off the electricity and inspect the wiring to see if anything has come loose or corroded. 

If you have a half-hot outlet, it means half of the outlet is controlled by a switch somewhere on the same circuit, which should be nearby. This is an intentional electrical design commonly found in rooms without overhead lights.

A home warranty usually covers electrical wiring work, depending on your specific plan. Most home warranty plans cover repairs for major appliances and home systems, including failure due to wear and tear. Home warranties aren’t as common as homeowners insurance, but they are more likely to cover old wiring.

A 60W LED bulb is likely labeled as “60W replacement” on the package—that’s because it provides about the same light output as a 60W incandescent bulb. In reality, it likely uses less energy—usually 15 watts or less. If that’s the case, then it’s perfectly fine to put a 60W LED bulb in a 40W socket. Your best bet is to read the package carefully. It will tell you the LED bulb’s actual wattage, and as long as it’s lower than the fixture, the bulb will be safe to use.

It can be safe to buy or live in a house with knob and tube (K&T) wiring, but only if the system is in good condition, functional, and has been thoroughly inspected and approved by a licensed electrician. Never purchase a home with K&T wiring without getting a professional electrical inspection first.

Key considerations include:

• Safety and Condition: An inspector will verify that the wiring is safe and has not deteriorated. Over time, the insulation can wear away, leaving exposed wires that pose a significant fire or shock hazard.

• System Capacity: The electrical service should be at least 60 amps. However, even at this capacity, K&T systems often struggle to handle the demands of modern appliances and electronics.

• Lack of Grounding: Knob and tube wiring is an ungrounded system, which is a safety concern for many modern devices.

• Ongoing Maintenance: If you live in a home with K&T wiring, it's recommended to have it inspected by an electrician every one to two years to ensure it remains in safe working order.

Ultimately, any inspection or modification of a knob and tube system should always be performed by a certified professional.