Top-rated fireplace cleaning pros.

Best fireplace cleaning pros near Midlothian, VA

Enter your zip and get matched with up to 5 pros

Need a pro for your fireplace cleaning project in Midlothian, VA?

Select your specific project to find the pro for you.

TRUSTED BY MIDLOTHIAN, VA HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon358
    Verified fireplace cleaning services reviews

Top-Rated Fireplace cleaning pros in Midlothian - Updated Nov 2026

Avatar for Neat Sweep
Neat Sweep
4.7(
251
)
Chimney or Fireplace - Clean and Inspect - For BusinessClean and Inspect a wood fireplace chimney

Serving Midlothian, VA and surrounding areas

In business since 1980

Emergency services offered

Credit card accepted

"Jet from Neat Sweep was fantastic! She was punctual, friendly, and went above and beyond. We were struggling with a worsening odor, and she found and removed a dead squirrel from my boiler exhaust. Without being asked, she cleaned out the exhaust piping and then recommended to me the components that weren't salvageable, and how and where I could replace them. By the end of the night, my chimneys were clean, and my home smelled fresh once again. Thank you for your great service!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+5

Recommended by95%of homeowners
Avatar for Capital City Chimney & Exterior Services
Capital City Chimney & Exterior Services
4.7(
21
)
Chimney or Fireplace - Clean and Inspect

Serving Midlothian, VA and surrounding areas

In business since 2019

Free estimates

Welcome to Capital City Chimney & Exterior Services! We take pride in the quality of work and customer satisfaction that we give each and every customer! We are known to pay exquisite attention to detail, while making customer satisfaction our top priority. Call us today to learn more about how we can help you.

Response time10 hrs
Response rate99%
Recommended by95%of homeowners
A-1 Chimney Sweep and Power Wash
3.7(
141
)
Chimney or Fireplace - Clean and InspectChimney or Fireplace - Clean and Inspect - For BusinessClean and Inspect a wood fireplace chimney

Serving Midlothian, VA and surrounding areas

In business since 2005

Emergency services offered

"      We have a wood fireplace that has 3 individual sides. I ordered the 3 pieces from a dealer (manufacturer went out of business). They sent 3 pieces that didn't quite fit right and A1 chimney fixed it perfectly. There was a bit more involved but I don't remember the details. Great job and we will continue using them.
"
rebuild
after
crownseal and repair
Recommended by60%of homeowners
Showing 1-10 of 40
Fireplace Cleaners FAQs, answered by experts

Here's the deal with leaving used rags covered in oil-based stain lying around in a pile: Depending on the conditions, these rags can take just an hour or up to a few days to combust. The source of ignition is caused by trapped heat that can be compounded if the rags are near a heat source.

You can turn a red brick white through a process called whitewashing. Whitewash isn’t a stain but rather is made from water and white latex paint. Adding more water to the mix will make the solution look lighter when applied, and adding more paint will make it look more white.

You should use an angled brush to first paint the mortar lines, then go in with a high-density roller to evenly paint the bricks one at a time. You can also use a flat paintbrush to paint individual bricks, but a roller is faster and easier to use thanks to its longer handle and wider surface area for coating the bricks. To finish, go in with the paint brush for edges or hard-to-reach areas.

Yes, you can limewash surfaces other than brick. Plaster, stone, stucco, and concrete can all also be limewashed. Any porous surface that will absorb the wash is a good candidate for limewash, although it won’t help much with waterproofing. If you choose to limewash over paint, you’ll need to prep before applying it to avoid a powdery, chalky finish. Shiny surfaces like metal or glass can’t absorb limewash, so it’s not suited for these.

Yes, brick should be clean before staining to ensure the best results. Dirt, dust, mold, mildew, and other substances on the brick can prevent the stain from properly adhering to it. Thoroughly cleaning the brick allows the stain to penetrate and bond to the surface more effectively. Cleaning typically involves using a pressure washer or a stiff brush with mild detergent. However, stubborn residue may require a specialized masonry cleaner.

The Midlothian, VA homeowners’ guide to fireplace cleaning services

From average costs to expert advice, get all the answers you need to get your job done.