Get matched with top water heater pros in Moore, OK

A water heater is one of the heaviest hitters in your home, and it needs as much power as possible to help it run efficiently and effectively.

Your water heater should be on its own dedicated circuit breaker, with no other power sources running to it. This is required to meet the National Electric Code–and to ensure it runs as efficiently as possible.

When the water expands in a hot water heater, it puts pressure on your hot water pipes and can cause leaks or a rupture in the hot water tank under certain conditions. Pipes or water heaters may split due to the pressure where there is a backflow preventer that prevents the hot water heater from diffusing pressure by releasing water back to the public water line.

In these scenarios, a hot water heater expansion tank provides a place for the hot water heater to relieve pressure and prevent bursts and leaks.

Several signs indicate your water heater may be failing or in need of replacement. Key indicators include:

• Age: A water heater older than ten years is approaching the end of its typical lifespan.

• Water Quality: If you notice rusty or discolored water from your hot water faucets, or a foul odor similar to rotten eggs or sulfur, it can signal internal corrosion.

• Unusual Noises: Banging, rumbling, or popping sounds from the tank often mean sediment has built up, causing the unit to overheat.

• Leaks: Any water pooling around the base of the tank or visible leaks are clear signs of failure.

• Performance Issues: A decline in performance, such as water not getting hot enough, taking longer to heat up, low water pressure, or decreased efficiency, suggests the unit is struggling.

• Visible Damage: Obvious rust and corrosion on the exterior of the tank can indicate a more serious internal problem.

While these signs often point to replacement, some issues may be fixable. It's best to consult a professional plumber to diagnose the problem before investing in a new unit.

Yes, you can convert a gas water heater to an electric one, but it is a complex process. You will need to ensure there is adequate power for the new electric unit, as they require more power than gas models. The project also involves safely closing off the gas lines and ventilation, and some cities may require a permit for the conversion. The cost can range from $1,500 to $4,100, depending on the installation scope, plumbing and electrical work, and the water heater model. For an accurate quote, it's best to contact a local professional. Also, be aware that your monthly utility bills may increase after the conversion, as natural gas is typically cheaper than electricity.