Get matched with top electricians in Powhatan Point, OH

If you strictly adhere to electrical safety rules, including assuming that a circuit is hot until proven otherwise, and have some knowledge of how an electrical circuit works, you can likely replace a light switch by yourself without too much trouble. However, it's always advisable to call a nearby electrical pro to do the job if you're unsure of any steps necessary to change a light switch. 

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

No, technically, the original Federal Pacific (FPE) breakers are no longer available. Stab-Lok® circuit breakers from the now-defunct Federal Pacific Electric Company (FPE) are no longer produced. However, the trademark and manufacture of the Stab-Lok® brand of breakers has been passed through a series of parent and subsidiary companies. Black and gray versions of the circuit breaker have been produced by these companies, with sales rights in the U.S. and Canada shifting back and forth.

You should never plug a normal 120v appliance into a special 240v outlet, as it can quickly burn out the appliance. This will cause irreparable damage to the appliance and, in worse case scenarios, cause damage to your circuit breaker. Check your appliance’s rating before plugging it into a 220v outlet to avoid electrical disaster.